Voltage from the Engine Control Module (ECM) is applied to the Water In Fuel Filter Sensor when the ignition switch is in the ON position. If water is detected, the Water In Fuel Filter sensor will notify the driver to drain the water from the bowl by illuminating a lamp on the dash of the vehicle.

Conditions for diagnostic trouble code (DTC):
1) The function has been activated

Probable cause
1) Priming pump

Detailed information
1) No fault

Reviews

There are no reviews yet.

Be the first to review “Volvo All Engines (2010 Emissions) Fault Code: SPN 97 FMI 14 PID: Water in Fuel Indicator”

Volvo All Engines (2010 Emissions) Fault Code: SPN 97 FMI 14 PID: Water in Fuel Indicator

Related

Reviews

Cumminmms Insiter 8.9 Diagnostic Software

JPRO Diagnostic Software Download 2024

AGCO EDT 2023.10 Electronic Diagnostic Tool 1.125

DOOSAN DMS-5 3.1.3 [2023.11] diagnostic software 1PC

CAT ET 2021A (Caterpillar Electronic Technician) + Factory Password (1 PC )

VOLVO IMPACT 2022 V.9227 offline

CAT SIS caterpillar 2021 Full Service Dealer

Magic Tuner [paccar, Maxxforce, Detroit, Caterpillar, Delete]

DPF EGR SCR BAC ERG Delete & Flash CAAT Cummings Detroit Dodge Mack Volvo Collection of DELETE files

Allison doc premium update 2023 v1 Diagnostic Software Download

volvo Devtool Studio V2 / V3 / V4 Developer tool plus 2.6 / 2.7

John Deere & Hitachi Parts ADVISOR 2020 [08.2020] Offline DVD Spare Parts Catalog

Diagnostic Software PSI Powerlink 2.3.1

Bendix Acom Pro 2022 v3 ( 1 PC ) BENDIX 2022 V3

JPRO 2022 v3 ( 1 PC )

MAN MANTIS v666 EPC [09.2021] Spare Parts Catalog

CAT ET Electronic Technician 2018C

Perkins EST 2022A ( 1 PC )

Volvo I-Shift service manual PDF

Related products

Allison 1000 & 2000 Gen 5 Fault Code:P097C Shift Solenoid 3 (SS3) Control Circuit – Open

Allison 1000 & 2000 Gen 5 Fault Code:U0074 CAN Communications BUS 2 Off

Allison 1000 & 2000 Gen 5 Fault Code:P2685 Actuator Supply Circuit Voltage 3 Low (HSD3)

Allison 1000 & 2000 Gen 5 Fault Code:U0100 Lost Communication With ECM A

Allison 1000 & 2000 Gen 5 Fault Code:P2637 Torque Management Feedback Signal – SEM

Allison 1000 & 2000 Gen 5 Fault Code:P0979 Shift Solenoid 3 (SS3) Control Circuit – Low

Allison 1000 & 2000 Gen 5 Fault Code:P0974 Shift Solenoid 1 (SS1) Control Circuit – High

Allison 1000 & 2000 Gen 5 Fault Code:P2727 Pressure Control Solenoid 1 (PCS1) Control Circuit – Open

Allison 1000 & 2000 Gen 5 Fault Code:U0073 CAN Communication Bus 1 Off

Allison 1000 & 2000 Gen 5 Fault Code:P0977 Shift Solenoid 2 (SS2) Control Circuit – High

Allison 1000 & 2000 Gen 5 Fault Code:P0980 Shift Solenoid 3 (SS3) Control Circuit – High

Allison 1000 & 2000 Gen 5 Fault Code:P1891 Throttle Position Sensor (TPS) PWM Signal – Low Input

Volvo All Engines (2010 Emissions) Fault Code: SPN 4339 FMI 0 PID: PSID 90 Aftertreatment SCR Feedback Control Status

Allison 3000 & 4000 Gen 4 Fault Code: P2789 Clutch Adaptive Learning at Limit

Allison WTEC II Fault Code: 51 PID: SPN: 45 FMI: Offgoing ratio test (during shift), 4 to 5

Cummins X12 CM2350 X119B (2018 & Newer) Fault Code: 4524 PID: SPN: 5862 FMI: 0 Aftertreatment 1 SCR Intermediate Gas Temperature- Data Valid But Above Normal Operating Range- Most Severe Level

Detroit DD16 EPA07 (2007-09) Fault Code: SPN 973 FMI 13 (CPC) Engine Retarder Selection Signal is Missing

Detroit DD15 EPA07 (2007-09) Fault Code: SPN 1077 FMI 7 (MCM) Rail Pressure Deviation is Greater the 200 Bar for Eight Seconds

Volvo All Engines (2017 Emissions) Fault Code: P26E900 PID: ACM Actuator Supply Voltage “D”

Cummins ISL CM850 (2003-06) Fault Code: 2976 PID: SPN: 3361 FMI: 2 Dosing Control Unit Temperature – Data Erratic, Intermittent, or Incorrect. An internal error has been detected in the catalyst dosing control unit.

Allison WTEC II Fault Code: 53 PID: SPN: 29 FMI: Offgoing speed test (during shift), 2 to N2

Detroit DD16 EPA10 (2010-13) Fault Code: SPN 3480 FMI 16 (MCM) High Hydrocarbon Doser Supply Pressure High

Cummins ISX CM870 (2003-06) Fault Code: 2321 PID: P190 SPN: 190 FMI: 2/2 Engine speed/position sensor number 1 – engine speed/position glitch detect (crankshaft sensor).

Detroit DD13 EPA10 (2010-13) Fault Code: SPN 3363 FMI 4 (ACM) Diesel Exhaust Fluid Valve Circuit Failed Low

Detroit DD13 GHG14 (2014-16) Fault Code: SPN 164 FMI 2 (MCM) Fuel Rail Pressure Drift High

Detroit DD13 GHG14 (2014-16) Fault Code: SPN 2631 FMI 1 (MCM) Low Air Flow

Volvo All Engines (2017 Emissions) Fault Code: P040398 PID: EMS EGR “A” Control

Cummins ISB CM850 (2003-06) Fault Code: 1717 PID: SPN: 3241 FMI: 15 Exhaust Gas Temperature 1 ? Data Valid but Above Normal Operational Range ? Least Severe Level. High catalyst inlet temperature has been detected.

PACCAR PX-9 CM2350 (2013-17) Fault Code:1881 PID:SID 324 SPN:3251 FMI:4 Aftertreatment Diesel Particulate Filter Differential Pressure Sensor Circuit – Voltage Below Normal or Shorted to Low Source

PACCAR PX-9 CM2350 (2013-17) Fault Code:1695 PID:SID 232 SPN:3513 FMI:3 Sensor Supply 5 – Voltage Above Normal or Shorted to High Source

Store

About

Features

Follow Us