Volvo Engine D13F Fault Code: SID 22 FMI 2 Timing Sensor, Crank
Volvo Engine D13F Fault Code: SID 22 FMI 2 Timing Sensor, Crank
CONTROL UNIT:
Engine ECU
DETECTION CONDITIONS:
The engine control unit (E-ECU) registers intermittent signal loss or signal error.
SYMPTOM:
1. Engine runs rough/varying engine speed.
2. Misfiring.
3. Engine is difficult to start, only after a long time of cranking.
4. Fuel consumption higher than normal.
POSSIBLE CAUSES:
1. Electric interference on speed signal.
2. Loose connection.
3. Poor insulation or defective cable.
4. Incorrectly installed sensor.
5. Defective sensor.
6. Damaged gear teeth on flywheel.
Related
-
Volvo Intermediate Storage File Encryptor/Decryptor (Editor) VISFED 0.3.2
Trucks software $35.00Rated 0 out of 5 -
International Truck ISIS – Oncommand Service Information Q4.2020 [04.2020]
Navistar $85.00Rated 0 out of 5
Related products
-
SERVICE MANUAL International Engines DT466 & DT530 (1995-1998)
INTERNATIONAL ENGINES $34.00Rated 0 out of 5 -
SERVICE MANUAL INTERNATIONAL ENGINE VT365 (2003 & Older)
INTERNATIONAL ENGINES $24.00Rated 0 out of 5