The Compressor Discharge Temperature Sensor is used to monitor the temperature of the air coming from the compressor side of the turbocharger.
The sensor signals are used for engine protection for high compressor out temperature and are monitored by the (ECU) Engine Control Unit.
The engine control module (ECM) will set a diagnostic trouble code (DTC) and derate the engine to avoid engine damage if the sensor signal is not within predetermined limits, or the signal is not rational.

Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A14.EB:43 is more than 4.843?V

Probable cause
1) Compressor Discharge Temperature Sensor
2) Wiring harness

Reviews

There are no reviews yet.

Be the first to review “Volvo All Engines (2010 Emissions) Fault Code: SPN 2629 FMI 5 PID: 404 Engine Turbocharger 1 Compressor Outlet Temperature”

Volvo All Engines (2010 Emissions) Fault Code: SPN 2629 FMI 5 PID: 404 Engine Turbocharger 1 Compressor Outlet Temperature

Related

Reviews

Cumminmms Insiter 8.9 Diagnostic Software

JPRO Diagnostic Software Download 2024

AGCO EDT 2023.10 Electronic Diagnostic Tool 1.125

DOOSAN DMS-5 3.1.3 [2023.11] diagnostic software 1PC

Bobcat Software Service Analyzer Version 87.07 ( 1PC )

Detroit Diesel Diagnostic Link DDDL 6.50 ( software trucks )

Volvo Impact 2021 Trucks & Buses 06.2021 DVD 9116 Spare Parts Catalog

NEXIQ eTechnician 2.1.7657.26963 + Patch 2020

Thermo King EPC 2012

Allison DOC 2019 PC software + GEN5 2019 truck

Allison DOC 2021 V2 (1PC)

CAT ET Electronic Technician 2019C

John Deere Service Advisor 5.3 CF & AG 2020.08

DDDL 8.17 2023 Detroit Diesel Diagnostic Link Software

Bendix Acom Pro 2023 V1 diagnostic software 1PC

John Deere & Hitachi Parts ADVISOR 2020 [08.2020] Offline DVD Spare Parts Catalog

Cat Factory Password Generator 1.0 2019 WINDOWS 10

Scania SDP3 2.48.6 Diagnosis & Programming for VCI 3 VCI3 without Dongle

Allison Doc Premium Update 2023 v2

Related products

Cummins ISB4.5 CM2150 Fault Code: 2265 PID: SID 126 SPN: 1075 FMI: 3 Electric Lift Pump for Engine Fuel Supply Circuit – Voltage Above Normal or Shorted to High Source.

Cummins ISB4.5 CM2150 Fault Code: 2556 PID: SPN: 729 FMI: 4 Engine Intake Air Heater 1 Circuit – Voltage Below Normal or Shorted to Low Source.

Cummins ISB4.5 CM2150 Fault Code: 2183 PID: 477 SPN: 1072 FMI: 4 Engine Brake Actuator Driver 1 Circuit – Voltage Below Normal or Shorted to Low Source.

Cummins ISB4.5 CM2150 Fault Code: 2963 PID: 110 SPN: 110 FMI: 0 Engine Coolant Temperature – Data Valid But Above Normal Operating Range – Least Severe Level.

Cummins ISB4.5 CM2150 Fault Code: 3555 PID: SPN: 1081 FMI: 9 Engine Wait to Start Lamp – Abnormal Update Rate.

Cummins ISB4.5 CM2150 Fault Code: 4484 PID: SPN: 4484 FMI: 7 Engine Air Shutoff Circuit – Mechanical System Not Responding or Out of Adjustment.

Cummins ISB4.5 CM2150 Fault Code: 3539 PID: SPN: 51 FMI: 3 Engine Intake Throttle Actuator Position Sensor Circuit – Voltage Above Normal or Shorted to High Source.

Cummins ISB4.5 CM2150 Fault Code: 3697 PID: SID 254 SPN: 630 FMI: 12 Engine Control Module Calibration Memory – Bad Intelligent Device or Component.

Cummins ISB4.5 CM2150 Fault Code: 2369 PID: SPN: 1074 FMI: 4 Engine (Exhaust) Brake Driver Circuit – Voltage Below Normal or Shorted to Low Source.

Cummins ISB4.5 CM2150 Fault Code: 3541 PID: SPN: 51 FMI: 4 Engine Intake Throttle Actuator Position Sensor Circuit – Voltage Below Normal or Shorted to Low Source.

Cummins ISB4.5 CM2150 Fault Code: 3139 PID: SPN: 3667 FMI: 3 Engine Air Shutoff Circuit – Voltage Above Normal or Shorted to High Source.

Cummins ISB4.5 CM2150 Fault Code: 2367 PID: SID 80 SPN: 1073 FMI: 3 Engine Brake Actuator Driver Output 2 Circuit – Voltage Above Normal or Shorted to High Source.

PACCAR PX-6 CM2150 (2007-09) Fault Code: 295 PID: 108 SPN: 108 FMI: 2 Barometric Pressure – Data Erratic, Intermittent, or Incorrect. The ambient air pressure sensor is reading an erratic value at initial key-on.

Cummins ISX11.9 CM2250 (2010-12) Fault Code: 3495 PID: SPN: 3711 FMI: 31 Diesel Particulate Filter Active Regeneration Inhibited Due to Low Exhaust Gas Temperature- Condition Exists

Cummins ISB4.5 CM2150 Fault Code: 1843 PID: 101 SPN: 101 FMI: 3 Crankcase Pressure Circuit – Voltage Above Normal or Shorted to High Source.

Cummins X15 CM2350 X116B Performance Series (2018 & Newer) Fault Code: 3697 PID: SID 253 SPN: 630 FMI: 12 Engine Control Module Calibration Memory- Bad Intelligent Device or Component

PACCAR PX-9 CM2350 (2013-17) Fault Code:3575 PID: SPN:4334 FMI:0 Aftertreatment 1 Diesel Exhaust Fluid Pressure – Data Valid But Above Normal Operating Range – Moderately Severe Level

Cummins ISX15 CM2250 (2010-12) Fault Code: 784 PID: SID 145 SPN: 1590 FMI: 2 Adaptive Cruise Control Mode- Data Erratic, Intermittent, or Incorrect

Cummins ISB CM850 (2003-06) Fault Code: 689 PID: 190 SPN: 190 FMI: 2 Engine Crankshaft Speed/Position – Data Erratic, Intermittent, or Incorrect. Loss of signal from crankshaft sensor.

Volvo All Engines (2013 Emissions) Fault Code: P008B00 PID: EMS Low Pressure Fuel System Pressure – Too High

Volvo All Engines (2017 Emissions) Fault Code: P06B100 PID: ACM Sensor Power Supply “A” Circuit Low

Cummins ISC CM2150 (2007-09) Fault Code: 1676 PID: SPN: 3249 FMI: 2 Aftertreatment Exhaust Gas Temperature 2 – Data Erratic, Intermittent, or Incorrect. The aftertreatment diesel particulate filter inlet temperature sensor is not changing with engine operating conditions.

Detroit DD15 GHG14 (2014-16) Fault Code: SPN 2791 FMI 9 (MCM) Smart Remote Actuator 3 (EGR), No Communication

Detroit DD15 EPA07 (2007-09) Fault Code: SPN 597 FMI 13 (CPC) J1939 Service Brake Switch Signal from Source #1, #2, Or #3 is Missing

Volvo All Engines (2017 Emissions) Fault Code: P117600 PID: EMS Starter Motor Deactivated – Over Temperature

Cummins ISB CM850 (2003-06) Fault Code: 146 (Marine) PID: 100 SPN: 110 FMI: 0 Engine Coolant Temperature – Data Valid but Above Normal Operational Range – Moderately Severe Level. Engine coolant temperature signal indicates engine coolant temperature is above engine protection warning limit.

PACCAR PX-9 CM2350 (2013-17) Fault Code:1923 PID:SID 334 SPN:3482 FMI:3 Aftertreatment Fuel Shutoff Valve Circuit – Voltage Above Normal or Shorted to High Source

Cummins X12 CM2350 X119B (2018 & Newer) Fault Code: 2962 PID: PID 412 SPN: 412 FMI: 16 Exhaust Gas Recirculation Temperature- Data valid But Above Normal Operational Range- Moderately Severe Level

Cummins ISX15 CM2250 (2010-12) Fault Code: 2311 (BCL) PID: SID 18 SPN: 633 FMI: 31 Electronic Fuel Injection Control Valve Circuit- Condition exists

Cummins ISX CM870 (2003-06) Fault Code: 559 PID: P157 SPN: 157 FMI: 1/18 Injector Metering Rail 1 Pressure – Data Valid But Below Normal Operating Range – Moderately Severe Level. The engine control module (ECM) has detected that fuel pressure is lower than commanded pressure.

Store

About

Features

Follow Us