Detroit DD15 EPA10 (2010-13) Fault Code: SPN 2659 FMI 18 (MCM) Exhaust Gas Recirculation Flow Target Error Diagnostic – Low Flow
DESCRIPTION:
This fault code sets when the different between the actual EGR flow and the commanded EGR flow is lower than a calibrated threshold.
MONITORED PARAMETER:
EGR mass flow
TYPICAL ENABLING CONDITIONS:
1. Desired EGR mass flow greater than .08.
2. EGR in closed loop control.
3. CAC outlet temperature greater than 0°C (32°F).
4. Engine speed 1080 to 2500 rpm.
5. Engine torque 200 to 2500 N·m (148 to 1844 lb·ft).
6. Coolant temperature greater than 65°C (149°F).
7. Ambient temperature greater than -8°C (18°F) ambient.
8. Barometric pressure greater than 755 mbar (11 psi).
MONITOR SEQUENCE:
None
EXECUTION FREQUENCY:
Always enabled
TYPICAL DURATION:
20
DASH LAMPS:
MIL
ENGINE REACTION:
None
VERIFICATION:
1. Start engine.
2. Warm up so that coolant temperature is greater than 65°C (149°F).
3. Ensure ambient temperature greater than -8°C (18°F).
4. Ambient barometric pressure greater than 755 mbar (11 psi).
PROBABLE CAUSES:
1. EGR delta p sensor.
2. EGR delta p harness/connector.
3. EGR delta p sensor port.
4. EGR valve.
Related products
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1301 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P1779 Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1064 J1850 (Class 2) TBC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1300 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0873 Transmission Pressure Switch Solenoid E Circuit High
1000 & 2000 Gen 4 $50.00 -
-
-
Bendix ABS EC-30 Fault Code: SID 251 FMI 3
Bendix ABS -
-
