Volvo All Engines (2017 Emissions) Fault Code: P102800 PID: EMS Cold Start Cylinder 6 Fuel Injector Offset Learning at Max Limit
Volvo All Engines (2017 Emissions) Fault Code: P102800 PID: EMS Cold Start Cylinder 6 Fuel Injector Offset Learning at Max Limit
Fuel Injector operation is controlled by the Engine Control Module (ECM). The ECM provides a common supply voltage to injectors 1,2,3 (Bank 1) and there are individual output transistor drivers inside the ECM to control each individual injector’s ground circuits. There are two solenoid circuits within the injector; a Needle Control Valve and a Spill Valve. Although they are separate circuits, the same fault code is used to identify a fault in the Needle Control Valve circuit and/or the Spill Valve circuit.
Conditions for diagnostic trouble code (DTC):
1) Injector (INJ) activated
2) Cylinder balancing data too high
Observable symptoms
1) Low Power
2) Uneven operation
3) Abnormal noise
Probable cause
1) Excessive wear or damage to cylinder liners, piston, or piston rings
2) Valves and rocker arms
3) Camshaft
4) VCB control valve sticking or slow to close
5) Injector
Related
-
International Truck ISIS – Oncommand Service Information Q4.2020 [04.2020]
Navistar $85.00Rated 0 out of 5 -
Hino Diagnostic eXplorer 2 – Hino DX2 1.1.19.1 with keygen unlocked ( Hino trucks )
Hino $50.00Rated 0 out of 5 -
10 IN 1 FOR CAT SIS Caterpillar 2021 Full Service Dealer INCLUDING CAT 2019 C
CAT $110.00Rated 0 out of 5
Related products
-
Volvo All Engines (2004 Emissions) Fault Code: PID 108 FMI 3 Ambient Pressure Sensor
All Engines (2004 Emissions)Rated 0 out of 5 -
Volvo All Engines (2004 Emissions) Fault Code: PID 412 FMI 0 EGR Temperature After Cooler
All Engines (2004 Emissions)Rated 0 out of 5 -
Volvo All Engines (2004 Emissions) Fault Code: SID 146 FMI 3 EGR Control Valve
All Engines (2004 Emissions)Rated 0 out of 5 -
Volvo All Engines (2004 Emissions) Fault Code: PID 26 FMI 8 Fan Speed
All Engines (2004 Emissions)Rated 0 out of 5 -
Volvo All Engines (2004 Emissions) Fault Code: PID 412 FMI 3 EGR Temperature After Cooler
All Engines (2004 Emissions)Rated 0 out of 5 -
Volvo All Engines (2004 Emissions) Fault Code: SID 146 FMI 7 EGR Control Valve
All Engines (2004 Emissions)Rated 0 out of 5 -
Volvo All Engines (2004 Emissions) Fault Code: PID 49 FMI 9 ABS Status
All Engines (2004 Emissions)Rated 0 out of 5 -
Volvo All Engines (2004 Emissions) Fault Code: PID 102 FMI 2 Boost Air Pressure / Temperature Sensor
All Engines (2004 Emissions)Rated 0 out of 5 -
Volvo All Engines (2004 Emissions) Fault Code: PID 412 FMI 5 EGR Temperature After Cooler
All Engines (2004 Emissions)Rated 0 out of 5 -
Volvo All Engines (2004 Emissions) Fault Code: SID 21 FMI 2 Cam Speed Sensor
All Engines (2004 Emissions)Rated 0 out of 5 -
Volvo All Engines (2004 Emissions) Fault Code: SID 146 FMI 5 EGR Control Valve
All Engines (2004 Emissions)Rated 0 out of 5 -
Volvo All Engines (2004 Emissions) Fault Code: PPID 35 FMI 9 EGR Mass Flow Sensor
All Engines (2004 Emissions)Rated 0 out of 5 -
Volvo All Engines (2004 Emissions) Fault Code: PPID 35 FMI 5 EGR Mass Flow Sensor
All Engines (2004 Emissions)Rated 0 out of 5 -
Volvo All Engines (2004 Emissions) Fault Code: PID 412 FMI 9 EGR Temperature After Cooler
All Engines (2004 Emissions)Rated 0 out of 5 -
Volvo All Engines (2004 Emissions) Fault Code: PID 228 FMI 11 Calibration Factor
All Engines (2004 Emissions)Rated 0 out of 5
-
SERVICE MANUAL International Engines VT275 (2004 & Older)
INTERNATIONAL ENGINES $21.00Rated 0 out of 5