Voltage from the Engine Control Module (ECM) is applied to the Water In Fuel Filter Sensor when the ignition switch is in the ON position. If water is detected, the Water In Fuel Filter sensor will notify the driver to drain the water from the bowl by illuminating a lamp on the dash of the vehicle.

Conditions for diagnostic trouble code (DTC):
1) Short circuit to ground on A14.EB:8

Observable symptoms
1) Water in fuel indicator

Probable cause
1) Faulty sensor
2) Short circuit to ground in the component or wiring
3) Connector
4) Engine control module (ECM)

Reviews

There are no reviews yet.

Be the first to review “Volvo All Engines (2010 Emissions) Fault Code: SPN 97 FMI 4 PID: Water in Fuel Indicator”

Volvo All Engines (2010 Emissions) Fault Code: SPN 97 FMI 4 PID: Water in Fuel Indicator

Reviews

Cumminmms Insiter 8.9 Diagnostic Software

JPRO Diagnostic Software Download 2024

AGCO EDT 2023 Electronic Diagnostic Tool 1.125

DOOSAN DMS 5 3.1 [2023.11] diagnostic software 1PC

Volvo Impact 2021 Trucks & Buses 06.2021 DVD 9116 Spare Parts Catalog

JOHN DEERE PARTS ADVISOR & HITACHI 2.24.2 [2023.07] EPC

Detroit Diesel Diagnostic Link DDDL 6.50 ( software trucks )

Caterpillar CAT ET 2021B Electronic Technician + Factory Password (1PC)

Cumming Caltem 5.9.1 2022 ( 1 PC )

CUMMINnSsg INSITEr 8.7.0.86 PRO + ZAP-IT

Noregon JPRO 2023 V3 Diagnostic Software Download 1pc

Perkins EST 2021B v1.0 Active License + FPKG ( 1 PC )

DOWNLOAD CNH EST 9.8 ENGINEERING

Isuzu G IDSS 2020 Diagnostic Service System [08.2020] Release Full

MAN MANTIS v666 EPC [09.2021] Spare Parts Catalog

Detroit Diesel Diagnostic Link DDDL 8.0 PRO PROFESSIONAL Software trucks

CAT ET 2022A Advanced diagnostic software for Caterpillar equipment

Diamond Logic Builder DLB 2019 Database 2019

Cat Factory Password Generator 1.0 2019 WINDOWS 10

Related products

Allison 1000 & 2000 Gen 5 Fault Code:P0977 Shift Solenoid 2 (SS2) Control Circuit – High

Allison 1000 & 2000 Gen 5 Fault Code:P2685 Actuator Supply Circuit Voltage 3 Low (HSD3)

Allison 1000 & 2000 Gen 5 Fault Code:P2727 Pressure Control Solenoid 1 (PCS1) Control Circuit – Open

Allison 1000 & 2000 Gen 5 Fault Code:P2684 Actuator Supply Circuit Voltage 3 Open (HSD3)

Allison 1000 & 2000 Gen 5 Fault Code:P2686 Actuator Supply Circuit Voltage 3 High (HSD3)

Allison 1000 & 2000 Gen 5 Fault Code:P1790 Gear Shift Module 1 Calibration Invalid

Allison 1000 & 2000 Gen 5 Fault Code:P2789 Clutch Adaptive Learning at Limit

Allison 1000 & 2000 Gen 5 Fault Code:P2724 Pressure Control Solenoid 1 (PCS1) – Stuck On

Allison 1000 & 2000 Gen 5 Fault Code:P2641 Torque Management Feedback Signal – LRTP

Allison 1000 & 2000 Gen 5 Fault Code:P2763 TCC PCS Control Circuit High

Allison 1000 & 2000 Gen 5 Fault Code:P097B Shift Solenoid 2 (SS2) Control Circuit – Open

Allison 1000 & 2000 Gen 5 Fault Code:P0973 Shift Solenoid 1 (SS1) Control Circuit – Low

Cummins X15 CM2350 X116B Performance Series (2018 & Newer) Fault Code: 3574 PID: SPN: 4334 FMI: 18 Aftertreatment 1 Diesel Exhaust Fluid Pressure- Data Valid But Below Normal Operating Range- Moderately Severe Level

Detroit DD15 EPA07 (2007-09) Fault Code: SPN 171 FMI 2 (CPC) Ambient Temperature Sensor Data Erratic

Cummins X15 CM2350 X116B Performance Series (2018 & Newer) Fault Code: 5278 PID: SPN: 6802 FMI: 31 Aftertreatment 1 Diesel Exhaust Fluid Dosing System Frozen- Condition Exists

Detroit DD16 EPA10 (2010-13) Fault Code: SPN 558 FMI 1 (CPC) Incorrect Wiring of the Idle Validation Switch

PACCAR PX-9 CM2350 (2013-17) Fault Code:3596 PID: SPN:3596 FMI:2 Aftertreatment 1 Diesel Exhaust Fluid Pressure – Data Erratic, Intermittent, or Incorrect

Cummins ISB4.5 CM2150 Fault Code: 269 PID: SPN: 1195 FMI: 2 Antitheft Password Valid Indicator – Data Erratic, Intermittent, or Incorrect.

Cummins ISL CM850 (2003-06) Fault Code: 428 (Marine) PID: 97 SPN: 97 FMI: 3 Water-in-Fuel Indicator Sensor Circuit – Voltage Above Normal or Shorted to High Source. High voltage detected at the water-in-fuel circuit.

Detroit DD15 EPA10 (2010-13) Fault Code: SPN 1077 FMI 5 (MCM) Quantity Control Valve Current Too Low

PACCAR PX-6 CM2150 (2007-09) Fault Code: 253 PID: 98 SPN: 98 FMI: 1 Engine Oil Level – Data Valid But Below Normal Operational Range – Most Severe Level. Very low oil level has been detected by the oil level sensor.

Detroit DD16 GHG14 (2014-16) Fault Code: SPN 520327 FMI 3 (ACM) Under Pressurized Diesel Exhaust Fluid System

Cummins X12 CM2350 X119B (2018 & Newer) Fault Code: 6645 PID: SPN: 5569 FMI: 3 Aftertreatment 1 Diesel Particulate Filter 1 Soot Sensor ECU Internal Temperature 2 Circuit- Voltage Above Normal or Shorted to High Source

Allison WTEC II Fault Code: 65 PID: SPN: 00 FMI: Engine rating too high

Cummins ISB4.5 CM2150 Fault Code: 3566 PID: SPN: 5394 FMI: 4 Aftertreatment Diesel Exhaust Fluid Dosing Valve – Voltage Below Normal or Shorted to Low Source.

Detroit DD16 EPA07 (2007-09) Fault Code: SPN 2659 FMI 1 (MCM) Exhaust Gas Recirculation Flow Target Error (Low Flow)

Cummins ISX15 CM2250 (2010-12) Fault Code: 323 PID: SID 5 SPN: 655 FMI: 5 Injector Solenoid Driver Cylinder 5 Circuit- Current Below Normal or Open Circuit

Cummins ISB6.7 CM2350 (2013-17) Fault Code: 3342 PID: 91 SPN: 4752 FMI: 18 Engine Exhaust Gas Recirculation Cooler Efficiency- Data Valid But Below Normal Operating Range- Moderately Severe Level

Eaton Gen 1 (AutoShift) Fault Code: 31 PID: PID 62 FMI: 3 Engine Brake Relay Coil

Cummins ISL CM850 (2003-06) Fault Code: 1663 PID: SPN: 3241 FMI: 11 Catalyst Inlet Temperature Sensor Swapped with Outlet ? Condition Exists. The inlet and outlet catalyst temperature sensor connections are swapped.

Store

About

Features

Follow Us