Probable cause
1) Short circuit to ground, Signal wire
2) Connector
3) Faulty sensor, B97

Reviews

There are no reviews yet.

Be the first to review “Volvo All Engines (2010 Emissions) Fault Code: SPN 3241 FMI 4 PID: Aftertreatment 1 Exhaust Gas Temperature 1 – moderately severe level”

Volvo All Engines (2010 Emissions) Fault Code: SPN 3241 FMI 4 PID: Aftertreatment 1 Exhaust Gas Temperature 1 – moderately severe level

Reviews

CLAAS MetaDiag 2007 Update 2016

Isuzu US-IDSS 2024 Diagnostic

Isuzu E-IDSS 2023 Diagnostic Software

ISUZU G-IDSS Domestic Japan 2024 Diagnostic Software

DOWNLOAD VOLVO MATRIS 2.3.3

CAT ET 2024 Diagnostic Software for Heavy

John Deere Service Advisor 5.3 CF & AG 2020.08

CAT CDVR PC Software – Caterpillar Digital Voltage Regulator (CDVR) WINDOWS 10

Bell Cancomm 5.07.0 diagnostic software

PACCAR ESA 5.6

NAVISTAR DLB 2024 Diamond Logic Builder

Download Renault Trucks NG3 NG10 calculator v0.1

Cumminmms Insiter 8.9 Diagnostic Software

HINO EPC 2018 TRUCKS / BUSES 2018 EPC PARTS CATALOG

CAT SIS caterpillar 2021 Full Service Dealer

JPRO 2022 v3 ( 1 PC )

Navistar international OnCommand service information 2018 software trucks

ddct Detroit diesel calibration tool (DDCT) v4.5 English Include Calibrations & Metafiles

NAVISTAR NED 2024 Diagnostic Software

Related products

Allison 1000 & 2000 Gen 5 Fault Code:P2686 Actuator Supply Circuit Voltage 3 High (HSD3)

Allison 1000 & 2000 Gen 5 Fault Code:P0979 Shift Solenoid 3 (SS3) Control Circuit – Low

Allison 1000 & 2000 Gen 5 Fault Code:P2684 Actuator Supply Circuit Voltage 3 Open (HSD3)

Allison 1000 & 2000 Gen 5 Fault Code:P2763 TCC PCS Control Circuit High

Allison 1000 & 2000 Gen 5 Fault Code:U0073 CAN Communication Bus 1 Off

Allison 1000 & 2000 Gen 5 Fault Code:P2641 Torque Management Feedback Signal – LRTP

Allison 1000 & 2000 Gen 5 Fault Code:P2724 Pressure Control Solenoid 1 (PCS1) – Stuck On

Allison 1000 & 2000 Gen 5 Fault Code:U0100 Lost Communication With ECM A

Allison 1000 & 2000 Gen 5 Fault Code:P0980 Shift Solenoid 3 (SS3) Control Circuit – High

Allison 1000 & 2000 Gen 5 Fault Code:P0122 Pedal Position Sensor Circuit – Low Voltage

Allison 1000 & 2000 Gen 5 Fault Code:P2730 Pressure Control Solenoid 1 (PCS1) Control Circuit – High

Allison 1000 & 2000 Gen 5 Fault Code:P097B Shift Solenoid 2 (SS2) Control Circuit – Open

Cummins ISX12 CM2250 (2010-12) Fault Code: 2449 PID: SID 27 SPN: 641 FMI: 13 VGT Actuator Controller- Out of Calibration

Cummins ISM CM875 (2003-06) Fault Code: 2372 PID: P95 SPN: 95 FMI: 0/16 Fuel filter restriction moderately high – warning. Fuel filter is plugged or fuel inlet restriction is high.

Cummins X12 CM2350 X119B (2018 & Newer) Fault Code: 3319 PID: SPN: 3246 FMI: 3 Aftertreatment Diesel Particulate Filter Outlet Temperature Sensor Circuit- Voltage Above Normal or Shorted to High Source

Allison WTEC II Fault Code: 22 PID: SPN: 16 FMI: Output speed sensor reasonableness test

Detroit DD16 GHG14 (2014-16) Fault Code: SPN 111 FMI 18 (CPC) Coolant Level Low

PACCAR PX-8 CM2150 (2007-09) Fault Code: 2451 PID: SPN: 2789 FMI: 0 Turbocharger Turbine Inlet Temperature (Calculated) – Data Valid but Above Normal Operational Range – Moderately Severe Level. Turbocharger turbine inlet temperature has exceeded the engine protection limit.

Cummins X15 CM2450 X124B (2018 & Newer) Fault Code: 3596 PID: SPN: 4334 FMI: 2 Aftertreatment 1 Diesel Exhaust Fluid Pressure- Data Erratic, Intermittent, or Incorrect

Detroit DD13 EPA10 (2010-13) Fault Code: SPN 2791 FMI 14 (MCM) Exhaust Gas Recirculation Valve Actuator Failsafe Mode, Motor ON

Volvo All Engines (2013 Emissions) Fault Code: P115000 PID: EMS Throttle/Pedal Position Sensor/Switch “A/D” Voltage Correlation

Eaton Fuller Advantage (2017) Fault Code: 22 PID: SID 254 SPN: FMI: 14 ABS CAN Message: Special Instructions

Cummins ISB6.7 CM2350 (2013-17) Fault Code: 1239 PID: SPN: 2623 FMI: 3 Accelerator Pedal or Lever Position Sensor 2 Circuit- Voltage Above Normal or Shorted to High Source

Cummins ISX12 CM2250 (2010-12) Fault Code: 1879 PID: SID 324 SPN: 3251 FMI: 3 Aftertreatment Diesel Particulate Filter Differential Pressure Sensor Circuit- Voltage above Normal or Shorted to High Source

Cummins X15 CM2350 X116B Performance Series (2018 & Newer) Fault Code: 584 PID: SID 39 SPN: 677 FMI: 3 Starter Relay Driver Circuit- Voltage Above Normal or Shorted to High Source

Cummins ISL CM850 (2003-06) Fault Code: FC0005 PID: SPN: FMI: Exhaust Gas Temperature Sensor Number 1 Circuit – Voltage Below Normal, or Shorted to Low Source. Low signal voltage or open circuit detected at the Exhaust Gas Temperature Sensor circuit.

Detroit DD13 EPA10 (2010-13) Fault Code: SPN 4337 FMI 2 (ACM) Diesel Exhaust Fluid Metering Unit Temperature – Drift

Detroit DD13 EPA10 (2010-13) Fault Code: SPN 3464 FMI 3 (MCM) H Bridge Circuit Shorted to Battery

Volvo All Engines (2010 Emissions) Fault Code: SPN 4356 FMI 3 PID: PSID 102 Aftertreatment Diesel Exhaust Fluid (DEF) Line Heater 3

Detroit DD15 GHG14 (2014-16) Fault Code: SPN 5361 FMI 18 (MCM) Cylinder #4 Engine Smoothness Control/Quantity Excess

Store

About

Features

Follow Us