The Engine Oil Temperature/Level Sensor contains two resistors: One for engine oil temperature and one for engine oil level.

Conditions for diagnostic trouble code (DTC):
1) The voltage at pin A14.EA:31 is below normal value

Diagnostic operating conditions
1) Ignition key in ON position

Observable symptoms
1) High fuel consumption
2) The engine coolant temperature (ECT) gauge shows 0
3) Engine fan constantly engaged
4) Less powerful engine since the fan takes power from the engine

Probable cause
1) Connector
2) Wiring harness
3) Engine control module (ECM)

Reviews

There are no reviews yet.

Be the first to review “Volvo All Engines (2010 Emissions) Fault Code: SPN 175 FMI 4 PID: Engine Oil Temperature”

Volvo All Engines (2010 Emissions) Fault Code: SPN 175 FMI 4 PID: Engine Oil Temperature

Reviews

CLAAS MetaDiag 2007 Update 2016

Isuzu US-IDSS 2024 Diagnostic

Isuzu E-IDSS 2023 Diagnostic Software

ISUZU G-IDSS Domestic Japan 2024 Diagnostic Software

VOLVO PREMIUM TECH TOOL PTT 2.7.30 Developer + Devtool + INSTALATION VIDEO!

Bobcat Service Analyzer 92.10 2024

JPRO Diagnostic Software Download 2024

Detroit Diesel Diagnostic Link DDDL 6.50 ( software trucks )

NAVISTAR ENGINE CYLINDER PERFORMANCE ANALYZER V7.8.8.1

DOWNLOAD VOLVO MATRIS 2.3.3

premium volvo tech tool update 2.8.150 diagnostic software 1pc

DPF EGR SCR BAC ERG Delete & Flash CAAT Cummings Detroit Dodge Mack Volvo Collection of DELETE files

NEXIQ eTechnician 2.1.7657.26963 + Patch 2020

Volvo I-Shift service manual PDF

AGCO EDT 2023 Electronic Diagnostic Tool 1.125

Wabco PIN Code Calculator Diagnostic Software PIN 1 PIN 2

CAT Engine Reprogramming Tool for flash programming C1.8, C2.4, C3.8 & C3.3B + Guide

VOLVO PREMIUM TECH TOOL PTT 2.7.116 + APCI 2021 + devtool ( ONLINE )

Bendix 6.16 ACom Diagnostics ( bendix software trucks )

Related products

Cummins ISB4.5 CM2150 Fault Code: 4284 PID: SPN: 5793 FMI: 9 Desired Engine Fueling State – Abnormal Update Rate.

Cummins ISB4.5 CM2150 Fault Code: 2556 PID: SPN: 729 FMI: 4 Engine Intake Air Heater 1 Circuit – Voltage Below Normal or Shorted to Low Source.

Cummins ISB4.5 CM2150 Fault Code: 3539 PID: SPN: 51 FMI: 3 Engine Intake Throttle Actuator Position Sensor Circuit – Voltage Above Normal or Shorted to High Source.

Cummins ISB4.5 CM2150 Fault Code: 2555 PID: SPN: 729 FMI: 3 Engine Intake Air Heater 1 Circuit – Voltage Above Normal or Shorted to High Source.

Cummins ISB4.5 CM2150 Fault Code: 3737 PID: SID 115 SPN: 1675 FMI: 11 Engine Starter Mode Overcrank Protection – Condition Exists.

Cummins ISB4.5 CM2150 Fault Code: 2963 PID: 110 SPN: 110 FMI: 0 Engine Coolant Temperature – Data Valid But Above Normal Operating Range – Least Severe Level.

Cummins ISB4.5 CM2150 Fault Code: 4484 PID: SPN: 4484 FMI: 7 Engine Air Shutoff Circuit – Mechanical System Not Responding or Out of Adjustment.

Cummins ISB4.5 CM2150 Fault Code: 3383 PID: 411 SPN: 3058 FMI: 0 Engine Exhaust Gas Recirculation System – Data Valid But Above Normal Operating Range – Moderately Severe Level.

Cummins ISB4.5 CM2150 Fault Code: 3735 PID: SPN: 2884 FMI: 9 Engine Auxiliary Governor Switch – Abnormal Update Rate.

Cummins ISB4.5 CM2150 Fault Code: 2183 PID: 477 SPN: 1072 FMI: 4 Engine Brake Actuator Driver 1 Circuit – Voltage Below Normal or Shorted to Low Source.

Cummins ISB4.5 CM2150 Fault Code: 2363 PID: SID 80 SPN: 1073 FMI: 4 Engine Brake Actuator Driver Output 2 Circuit – Voltage Below Normal or Shorted to Low Source.

PACCAR Engine Analyzer v1.3.0.6

Cummins ISC CM2150 (2007-09) Fault Code: 386 PID: SID 212 SPN: 3509 FMI: 3 Sensor Supply 1 Circuit – Voltage Above Normal or Shorted to High Source. High voltage detected at sensor supply number 1 circuit.

Detroit DD13 GHG14 (2014-16) Fault Code: SPN 926 FMI 3 (MCM, CPC) Vehicle Power Shutdown that Indicates a Short to Power of the Common Powertrain Controller #4 Connector

Cummins X15 CM2450 X124B (2018 & Newer) Fault Code: 2223 (3 Wire) PID: PID 96 SPN: 96 FMI: 4 Fuel Level (Main Tank) Sensor Circuit- Voltage Below Normal or Shorted to Low Source

Detroit DD15 GHG14 (2014-16) Fault Code: SPN 3841 FMI 4 (CPC) Frequency Output 4 11 – Indicated By a Short to Ground on Pin 11 Circuit of the Common Powertrain Controller #4 Connector

Detroit DD16 EPA10 (2010-13) Fault Code: SPN 3031 FMI 4 (ACM) Diesel Exhaust Fluid Tank Temperature Sensor Circuit Failed Low

PACCAR PX-9 CM2350 (2013-17) Fault Code:3251 PID:S326 SPN:4765 FMI:0 Aftertreatment Diesel Oxidation Catalyst Intake Temperature – Data Valid But Above Normal Operating Range – Moderately Severe Level

Detroit DD15 EPA10 (2010-13) Fault Code: SPN 103 FMI 1 (MCM) Turbocharger Speed Below Threshold (High Box)

PACCAR MX (2004 Emissions) Fault Code: P1133 Lambda Sensor Heater – Voltage Too High or Short Circuit to Supply on ECU (D420) Pin (C46)

Detroit DD13 GHG14 (2014-16) Fault Code: SPN 3226 FMI 21 (ACM) NOx Outlet Sensor Drift High

Detroit DD15 GHG14 (2014-16) Fault Code: SPN 3849 FMI 3 (CPC) Digital Input 1 17 – Failed High on Pin 17 Circuit of the Common Powertrain Controller #1 Connector

Volvo All Engines (2017 Emissions) Fault Code: P06B400 PID: EMS Sensor Power Supply B Circuit Low

Volvo All Engines (2010 Emissions) Fault Code: SPN 2629 FMI 15 PID: 404 Engine Turbocharger 1 Compressor Outlet Temperature – Least Severe Level

Volvo All Engines (2010 Emissions) Fault Code: SPN 3249 FMI 5 PID: PPID 387 Aftertreatment DPF Intake Temperature

Cummins ISB CM850 (2003-06) Fault Code: 432 PID: SID 230 SPN: 558 FMI: 13 Accelerator Pedal or Lever Idle Validation Circuit – Out of Calibration. Voltage at idle validation on-idle and off-idle circuit does not match accelerator pedal position.

Detroit DD16 GHG14 (2014-16) Fault Code: SPN 520267 FMI 10 (MCM) Motor Control Module Engine Hours Data Erratic, Intermittent or Incorrect

Cummins X15 CM2350 X116B Performance Series (2018 & Newer) Fault Code: 3243 PID: SPN: 3060 FMI: 18 Engine Cooling System Monitor- Data valid But Below Normal Operating Range- Moderately Severe Level

Detroit DD15 EPA10 (2010-13) Fault Code: SPN 3719 FMI 0 (ACM) Soot Level Very High

Detroit DD15 GHG14 (2014-16) Fault Code: SPN 5246 FMI 0 (ACM) Regulatory Fault Ignored – Final Action (Speed Limit)

Store

About

Features

Follow Us