The (VECU) Vehicle Electronic Control Unit supplies and monitors the cranking signal to the starter motor relay. Several types of starter cranking protection are provided so the starter cannot be engaged in unwanted conditions. The starter cranking protection will also limit the maximum cranking time to 18 seconds without cycling the key.

Conditions for diagnostic trouble code (DTC):
1) Power take-off activated

Observable symptoms
1) Not possible to activate the starter motor

Probable cause
1) Power take-off switch

Detailed information
1) Put the power take-off switch in off position and try to start again

Reviews

There are no reviews yet.

Be the first to review “Volvo All Engines (2010 Emissions) Fault Code: SPN 1675 FMI 14 PID: SID 39 Engine Starter Mode”

Volvo All Engines (2010 Emissions) Fault Code: SPN 1675 FMI 14 PID: SID 39 Engine Starter Mode

Related

Reviews

Cumminmms Insiter 8.9 Diagnostic Software

JPRO Diagnostic Software Download 2024

AGCO EDT 2023.10 Electronic Diagnostic Tool 1.125

DOOSAN DMS-5 3.1.3 [2023.11] diagnostic software 1PC

AGCO EDT 2023.10 Electronic Diagnostic Tool 1.125

ZF Testman Pro ESB 10.5 2022

CAT SIS caterpillar 2021 Full Service Dealer

DOOSAN DMS-5 3.1.3 [2023.11] diagnostic software 1PC

Cumminmms Insiter 8.9 Diagnostic Software

Perkins EST 2021B v1.0 Active License + FPKG ( 1 PC )

CAT ET Electronic Technician 2019C

Meritor WABCO Toolbox 12.12 Software

CUMMINnSsg INSITEr 8.7.0.86 PRO + ZAP-IT

Bendix Acom Pro 2023 V1 diagnostic software 1PC

Allison Doc Premium Update 2023 v2

VOLVO PREMIUM TECH TOOL PTT 2.7.116 + APCI 2021 + devtool ( ONLINE )

DPF EGR SCR BAC ERG Delete & Flash CAAT Cummings Detroit Dodge Mack Volvo Collection of DELETE files

download Hitachi Construction Machinery MPDr Ver 3.7.0.0 [10.2020] Diagnostic Software

PACCAR Engine Analyzer v1.3.0.6

Related products

Cummins ISB4.5 CM2150 Fault Code: 2265 PID: SID 126 SPN: 1075 FMI: 3 Electric Lift Pump for Engine Fuel Supply Circuit – Voltage Above Normal or Shorted to High Source.

Cummins ISB4.5 CM2150 Fault Code: 3737 PID: SID 115 SPN: 1675 FMI: 11 Engine Starter Mode Overcrank Protection – Condition Exists.

Cummins ISB4.5 CM2150 Fault Code: 4284 PID: SPN: 5793 FMI: 9 Desired Engine Fueling State – Abnormal Update Rate.

Cummins ISB4.5 CM2150 Fault Code: 3735 PID: SPN: 2884 FMI: 9 Engine Auxiliary Governor Switch – Abnormal Update Rate.

Cummins ISB4.5 CM2150 Fault Code: 2963 PID: 110 SPN: 110 FMI: 0 Engine Coolant Temperature – Data Valid But Above Normal Operating Range – Least Severe Level.

Cummins ISB4.5 CM2150 Fault Code: 2367 PID: SID 80 SPN: 1073 FMI: 3 Engine Brake Actuator Driver Output 2 Circuit – Voltage Above Normal, or Shorted to High Source.

Cummins ISB4.5 CM2150 Fault Code: 111 PID: 629 FMI:12 Engine Control Module Critical Internal Failure – Bad Intelligent Device or Component

Cummins ISB4.5 CM2150 Fault Code: 2363 PID: SID 80 SPN: 1073 FMI: 4 Engine Brake Actuator Driver Output 2 Circuit – Voltage Below Normal or Shorted to Low Source.

PACCAR Engine Analyzer v1.3.0.6

Cummins ISB4.5 CM2150 Fault Code: 2183 PID: 477 SPN: 1072 FMI: 4 Engine Brake Actuator Driver 1 Circuit – Voltage Below Normal or Shorted to Low Source.

Cummins ISB4.5 CM2150 Fault Code: 3697 PID: SID 254 SPN: 630 FMI: 12 Engine Control Module Calibration Memory – Bad Intelligent Device or Component.

Cummins ISB4.5 CM2150 Fault Code: 3555 PID: SPN: 1081 FMI: 9 Engine Wait to Start Lamp – Abnormal Update Rate.

Detroit DD15 EPA10 (2010-13) Fault Code: SPN 3510 FMI 3 (ACM) Aftertreatment Control Module 2 Sensor Supply 2 Short to Battery

Volvo All Engines (2013 Emissions) Fault Code: P060141 PID: EMS Internal Control Unit Memory Checksum Error

Detroit DD13 EPA07 (2007-09) Fault Code: SPN 524 FMI 9 (CPC) J1939 ETC2 Message Missing

Detroit DD13 EPA10 (2010-13) Fault Code: SPN 3364 FMI 17 (ACM) Improper Diesel Exhaust Fluid Quality Warning

Cummins ISB4.5 CM2150 Fault Code: 2634 PID: SPN: 641 FMI: 12 VGT Actuator Controller – Bad Intelligent Device or Component.

Cummins ISX CM870 (2003-06) Fault Code: 2961 PID: P412 SPN: 412 FMI: 0/15 Exhaust Gas Recirculation Temperature – Data Valid But Above Normal Operating Range – Least Severe Level. Exhaust gas recirculation (EGR) temperature has exceeded the engine protection limit.

Cummins ISB CM850 (2003-06) Fault Code: 293 PID: 441 SPN: 441 FMI: 3 Auxiliary Temperature Sensor Input 1 – Voltage Above Normal, or Shorted to High Source. High signal voltage or open circuit detected at the OEM auxiliary temperature circuit.

Volvo All Engines (2013 Emissions) Fault Code: P06E616 PID: EMS Sensor Power Supply “C”

Allison 1000 & 2000 Gen 5 Fault Code:P2641 Torque Management Feedback Signal – LRTP

Volvo All Engines (2013 Emissions) Fault Code: P020156 PID: EMS Cylinder 1 Injector “A”

Volvo All Engines (2010 Emissions) Fault Code: SPN 653 FMI 7 PID: SID 3 Engine Injector Cylinder 3

Detroit DD15 GHG14 (2014-16) Fault Code: SPN 2623 FMI 2 (CPC) Accelerator Pedal In-Range Fault

Cummins ISB6.7 CM2150 (2007-09) Fault Code: 252 PID: 98 SPN: 98 FMI: 2 Engine Oil Level – Data Erratic, Intermittent, or Incorrect. An intermittent signal is being received from the oil level sensor.

Cummins ISX15 CM2250 (2010-12) Fault Code: 2198 PID: SID 27 SPN: 641 FMI: 11 VGT Actuator Driver Circuit- Root Cause Not Known

PACCAR PX-9 CM2350 (2013-17) Fault Code:1683 PID: SPN:3363 FMI:3 Aftertreatment 1 Diesel Exhaust Fluid Tank Heater – Voltage Above Normal or Shorted to High Source

Detroit DD16 GHG14 (2014-16) Fault Code: SPN 558 FMI 6 (CPC) Open Circuit; Idle Validation Switch 2 Circuit Failed High

Detroit DD15 EPA10 (2010-13) Fault Code: SPN 3659 FMI 6 (MCM) Injector Cylinder #1 Amplifier Control Valve – Valve Shorted Circuit

Detroit DD16 EPA10 (2010-13) Fault Code: SPN 4334 FMI 17 (ACM) Diesel Exhaust Fluid (DEF) Purge Pressure High

Store

About

Features

Follow Us