PACCAR MX (2004 Emissions) Fault Code: U1071 Inlet Air Humidity Before Compressor – Data Erratic, Intermittent or Incorrect
PACCAR MX (2004 Emissions) Fault Code: U1071 Inlet Air Humidity Before Compressor – Data Erratic, Intermittent or Incorrect
SET CONDITIONS:
The PCI ECU (D420) receives a CAN message from the humidity sensor (F852) that contains an out-of-range value for the relative humidity.
DIAGNOSTIC CONDITION:
This diagnostic runs continuously when the ignition is on.
CORRESPONDING OBD READINESS MONITOR:
None
RESET CONDITION:
This DTC changes to inactive after the ignition is keyed off for at least 15 seconds and keyed on again, and the fault is no longer detected.
REPAIR VERIFICATION:
1. Clear all DTCs.
2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.
3. Did the DTC come back?
– No, repair successful
– Yes, repair unsuccessful
POSSIBLE CAUSES:
1. E-CAN communication
2. Faulty humidity sensor
ADDITIONAL INFORMATION:
The humidity sensor is a smart sensor that communicates with the PCI ECU via E-CAN. The sensor measures the following three properties of the drawn in pre-compressor (VTG turbo charger) air in the inlet air pipe:
1. Relative humidity
2. Pressure
3. Temperature
-
DOWNLOAD Paccar ESA Electronic Service Analyst 5.5.0 Diagnostic Software 2023
PACCAR $96.00Rated 0 out of 5
-
Detroit Diesel Diagnostic Link DDDL 8.0 PRO PROFESSIONAL Software trucks
Detroit $25.00Rated 0 out of 5 -
Hino Diagnostic eXplorer 2 – Hino DX2 v1.1.21.4 with keygen unlocked ( Hino trucks )
Hino $60.00Rated 0 out of 5 -
Wabco ToolBox plus 13.7.0.1 + ECAS CAN2 v3.00 Diagnostics Software
Trucks software $84.00Rated 0 out of 5 -
2021 VOLVO PREMIUM TECH TOOL PTT V2.8.21 VCADS+DEVELOPER TOOL+APCI 2021/09 ( 1 PC )
Trucks software $85.00Rated 0 out of 5 -
Scania SDP3 2.48.6 Diagnosis & Programming for VCI 3 VCI3 without Dongle
Scania $30.00Rated 0 out of 5 -
CAT Engine Reprogramming Tool for flash programming C1.8, C2.4, C3.8 & C3.3B + Guide
CAT $50.00Rated 0 out of 5