PACCAR MX (2004 Emissions) Fault Code: U104C VTG Turbocharger Actuator – CAN Communication Error
PACCAR MX (2004 Emissions) Fault Code: U104C VTG Turbocharger Actuator – CAN Communication Error
SET CONDITIONS:
The VTG turbo charger actuator (L037) detects that the cyclic CAN command message transmitted by the PCI ECU (D420) is missing.
DIAGNOSTIC CONDITION:
This diagnostic runs continuously when the ignition is on.
CORRESPONDING OBD READINESS MONITOR:
None
RESET CONDITION:
This DTC will change to inactive immediately after the diagnostic runs and passes.
REPAIR VERIFICATION:
1. Clear all DTCs.
2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.
3. Did the DTC come back?
– No, repair successful
– Yes, repair unsuccessful
POSSIBLE CAUSES:
1. Communication error between actuator and PCI ECU
2. Faulty VTG turbocharger actuator
ADDITIONAL INFORMATION:
1. The VTG turbo charger actuator (L037) is controlled by a cyclic CAN command message transmitted by the PCI ECU (D420) in which the operating mode and the target position are demanded.
2. The actuator motor moves to a position of 80% and is switched off with this fault active.
-
Eaton Service Ranger 4.9 Engineering 4.9 [05.2021] Engineering Level ( 1 PC )
Eaton $67.00Rated 0 out of 5 -
CAT ET 2021A (Caterpillar Electronic Technician) + Factory Password (1 PC )
CAT $65.00Rated 0 out of 5 -
ddct Detroit diesel calibration tool (DDCT) v4.5 English Include Calibrations & Metafiles
Detroit $30.00Rated 0 out of 5 -
Navistar international OnCommand service information 2018 software trucks
Navistar $50.00Rated 0 out of 5
Related products
-
SERVICE MANUAL Eaton Fuller – Autoshift, Autoselect Service Manual (TRSM-0050)
EATON $25.00Rated 0 out of 5 -
SERVICE MANUAL DETROIT DIESEL DDEC III-IV Single ECM Troubleshooting Guide
DETROIT $48.00Rated 0 out of 5