PACCAR MX (2004 Emissions) Fault Code: U1014 CAN – Hardware or Software Malfunction on V-CAN1
PACCAR MX (2004 Emissions) Fault Code: U1014 CAN – Hardware or Software Malfunction on V-CAN1
SET CONDITIONS:
The PCI ECU detects a malfunction on V-CAN1.
DIAGNOSTIC CONDITION:
This diagnostic runs continuously after the ignition is switched on.
CORRESPONDING OBD READINESS MONITOR:
None
RESET CONDITION:
This DTC changes to inactive after the ignition is keyed off for at least 15 seconds and keyed on again, and the fault is no longer detected.
REPAIR VERIFICATION:
1. Clear all DTCs.
2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.
3. Did the DTC come back?
– No, repair successful
– Yes, repair unsuccessful
POSSIBLE CAUSES:
1. V-CAN1 wiring issue
2. V-CAN1 message overload
3. Malfunction of component connected to V-CAN1
-
Scania SDP3 2.48.6 Diagnosis & Programming for VCI 3 VCI3 without Dongle
Scania $30.00Rated 0 out of 5
Related products
-
SERVICE MANUAL Carrie Starbird TDB/TDS-215 and Starbird PlusTDB/TDS-219
CARRIE $24.00Rated 0 out of 5 -
SERVICE MANUAL International Engines MaxxForce DT 9 10 (2014 & Newer)
INTERNATIONAL ENGINES $17.00Rated 0 out of 5 -
SERVICE MANUAL DETROIT DIESEL EPA 07, EPA 10, GHG 14 TROUBLESHOOTING
DETROIT $38.00Rated 0 out of 5