PACCAR MX (2004 Emissions) Fault Code: P2580 Turbo Speed – Data Valid but Too Low, Least Severe on ECU (D420) Pin (C87)
PACCAR MX (2004 Emissions) Fault Code: P2580 Turbo Speed – Data Valid but Too Low, Least Severe on ECU (D420) Pin (C87)
SET CONDITIONS:
The PCI ECU (D420) detects that the turbo speed is below 30,000 rpm for more than 20 seconds.
DIAGNOSTIC CONDITION:
This diagnostic runs when the engine speed is above 1000 rpm, and the engine is moderately loaded.
RESET CONDITION:
This DTC changes to inactive when the fault is no longer detected.
POSSIBLE CAUSES:
1. Exhaust gas leakage between engine and VTG turbocharger
2. Loose turbo speed sensor (air gap too large)
3. Malfunction on the turbo speed sensor wiring
4. Malfunction on the turbo speed sensor
5. Restriction in exhaust or aftertreatment system
ADDITIONAL INFORMATION:
1. Turbo speed is measured by the turbo speed sensor (F683).
2. Engine torque is reduced when this DTC is active.
-
Scania SDP3 2.48.6 Diagnosis & Programming for VCI 3 VCI3 without Dongle
Scania $30.00Rated 0 out of 5 -
download MANCATS II v14.01 2014 Diagnostic software MAN CATS ( virtual machine )
MAN $75.00Rated 0 out of 5 -
Wabco ToolBox plus 13.7 + ECAS CAN2 v3.00 Diagnostics Software
Trucks software $84.00Rated 0 out of 5
Related products
-
SERVICE MANUAL DETROIT DIESEL DDEC III-IV Single ECM Troubleshooting Guide
DETROIT $48.00Rated 0 out of 5