PACCAR MX (2004 Emissions) Fault Code: P2580 Turbo Speed – Data Valid but Too Low, Least Severe on ECU (D420) Pin (C87)
PACCAR MX (2004 Emissions) Fault Code: P2580 Turbo Speed – Data Valid but Too Low, Least Severe on ECU (D420) Pin (C87)
SET CONDITIONS:
The PCI ECU (D420) detects that the turbo speed is below 30,000 rpm for more than 20 seconds.
DIAGNOSTIC CONDITION:
This diagnostic runs when the engine speed is above 1000 rpm, and the engine is moderately loaded.
RESET CONDITION:
This DTC changes to inactive when the fault is no longer detected.
POSSIBLE CAUSES:
1. Exhaust gas leakage between engine and VTG turbocharger
2. Loose turbo speed sensor (air gap too large)
3. Malfunction on the turbo speed sensor wiring
4. Malfunction on the turbo speed sensor
5. Restriction in exhaust or aftertreatment system
ADDITIONAL INFORMATION:
1. Turbo speed is measured by the turbo speed sensor (F683).
2. Engine torque is reduced when this DTC is active.
-
ddct Detroit diesel calibration tool (DDCT) v4.5 English Include Calibrations & Metafiles
Detroit $30.00Rated 0 out of 5
-
CAT Engine Reprogramming Tool for flash programming C1.8, C2.4, C3.8 & C3.3B + Guide
CAT $50.00Rated 0 out of 5 -
DPF EGR SCR BAC ERG Delete & Flash CAAT Cummings Detroit Dodge Mack Volvo Collection of DELETE files
CAT $200.00Rated 0 out of 5 -
PACCAR Electronic Service Analyst 5.4.3.0 SW files 27.03.2021 software trucks
PACCAR $60.00Rated 0 out of 5
Related products
-
SERVICE MANUAL Eaton Gen III Automated TransmissionsTRSM0930 EN-USOctober 2020
TRUCK MANUALS $24.00Rated 0 out of 5