PACCAR MX (2004 Emissions) Fault Code: P229C Common Rail Pressure Release Valve Current – Data Valid but Too Low
PACCAR MX (2004 Emissions) Fault Code: P229C Common Rail Pressure Release Valve Current – Data Valid but Too Low
SET CONDITIONS:
The PCI ECU (D420) detects that the common rail pressure release valve control current has been lower than expected for more than 6 seconds.
DIAGNOSTIC CONDITION:
This diagnostic runs when the rail pressure operating state is: Release valve only.
CORRESPONDING OBD READINESS MONITOR:
None
RESET CONDITION:
This DTC changes to inactive when the fault is no longer detected.
REPAIR VERIFICATION:
1. Clear all DTCs.
2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.
3. Did the DTC come back?
– No, repair successful
– Yes, repair unsuccessful
POSSIBLE CAUSES:
Faulty common rail pump unit (too much fuel is pumped to the rail)
ADDITIONAL INFORMATION:
1. The PCI ECU controls and checks the current of the common rail pressure release valve (L094). The current is controlled with a duty cycle.
2. When this DTC is active:
– The engine torque is reduced.
– The engine runs in protection mode.
– The rail pressure control is: Pump unit only.
– The rail pressure is limited to approximately 1300 bar.
-
Eaton Service Ranger 4.9 Engineering 4.9 [05.2021] Engineering Level ( 1 PC )
Eaton $67.00Rated 0 out of 5
-
JPRO 2022 v1 Commercial Vehicle Diagnostics V1 Software Download & Installation Service ( 1 PC )
JPRO $94.00Rated 0 out of 5 -
VOLVO PREMIUM TECH TOOL PTT 2.7.30 Developer + Devtool + INSTALATION VIDEO!
Trucks software $60.00Rated 0 out of 5 -
ddct Detroit diesel calibration tool (DDCT) v4.5 English Include Calibrations & Metafiles
Detroit $30.00Rated 0 out of 5
Related products
-
SERVICE MANUAL DETROIT DIESEL DDEC VI – Application And Installation Manual
DETROIT $20.00Rated 0 out of 5 -
SERVICE MANUAL International Engines MaxxForce 5 (2007 & 2009)
INTERNATIONAL ENGINES $25.00Rated 0 out of 5