PACCAR MX (2004 Emissions) Fault Code: P2181 Engine Coolant Temperature – Does not Match Engine Operating Conditions
PACCAR MX (2004 Emissions) Fault Code: P2181 Engine Coolant Temperature – Does not Match Engine Operating Conditions
SET CONDITIONS:
The PCI ECU (D420) detects that the measured coolant temperature differs by more than 10°C [50°F] from the expected coolant temperature for more than 30 seconds.
DIAGNOSTIC CONDITION:
This diagnostic runs:
1. 150 seconds after an engine start
2. When the ambient temperature is between -8 and 40°C [17 and 104°F]
3. When the engine mode is DOC heating or DPF regeneration or SCR heating or SCR high efficiency or standard or protection
CORRESPONDING OBD READINESS MONITOR:
None
RESET CONDITION:
This DTC changes to inactive when the fault is no longer detected.
REPAIR VERIFICATION:
1. Clear all DTCs.
2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.
3. Did the DTC come back? (Can be pending, inactive or active)
– No, repair successful
– Yes, repair unsuccessful
POSSIBLE CAUSES:
1. Blocked open thermostat
2. Excessive heat drawn from the cooling system
ADDITIONAL INFORMATION:
The engine coolant temperature is monitored by the coolant temperature sensor (F566).
-
ddct Detroit diesel calibration tool (DDCT) v4.5 English Include Calibrations & Metafiles
Detroit $30.00Rated 0 out of 5 -
PACCAR Electronic Service Analyst 5.4.3.0 SW files 27.03.2021 software trucks
PACCAR $60.00Rated 0 out of 5
-
Hino Diagnostic eXplorer 2 – Hino DX2 v1.1.21.4 with keygen unlocked ( Hino trucks )
Hino $60.00Rated 0 out of 5 -
VOLVO PREMIUM TECH TOOL PTT 2.7.30 Developer + Devtool + INSTALATION VIDEO!
Trucks software $60.00Rated 0 out of 5 -
Volvo Intermediate Storage File Encryptor/Decryptor (Editor) VISFED 0.3.2
Trucks software $35.00Rated 0 out of 5 -
Scania SDP3 2.48.6 Diagnosis & Programming for VCI 3 VCI3 without Dongle
Scania $30.00Rated 0 out of 5