PACCAR MX (2004 Emissions) Fault Code: P1723 Exhaust Gas Pressure Before Turbine – Data Valid but Too Low
PACCAR MX (2004 Emissions) Fault Code: P1723 Exhaust Gas Pressure Before Turbine – Data Valid but Too Low
SET CONDITIONS:
The PCI ECU (D420) detects that measured pressure before turbine is lower than the requested pressure before turbine for more than 40 seconds.
DIAGNOSTIC CONDITION:
This diagnostic runs:
1. When the engine speed is above 600 rpm and
2. When the engine is running at a steady load and
3. The [engine mode] is SCR HEATING, SCR HIGH EFFICIENCY, STANDARD or PROTECTION
CORRESPONDING OBD READINESS MONITOR:
None
RESET CONDITION:
This DTC changes to INACTIVE when the fault is no longer detected.
REPAIR VERIFICATION:
1. Clear all DTCs.
2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.
3. Did the DTC come back?
– No, repair successful
– Yes, repair unsuccessful
POSSIBLE CAUSES:
1. The end-stops of the VTG turbocharger actuator programmed incorrectly
IMPORTANT: Turbocharger actuators are occasionally recalibrated by a technician in an attempt to solve VTG turbocharger actuator position-related DTCs. By doing so, the actuator is mistakenly calibrated to a smaller span than the initial maximum span of the turbocharger mechanism. In that case the requested pressure before turbine cannot be reached, resulting in DTC P1723.
2. Leaking exhaust system
3. Leaking pressure sensor before turbine tube
4. Plugged pressure sensor before turbine tube
5. Pressure sensor before turbine deviation
ADDITIONAL INFORMATION:
1. The PCI ECU uses the pressure before turbine for, among other things, controlling the VTG turbocharger, EGR valve position, BPV valve position and engine braking.
2. The pressure before turbine is measured by the pressure sensor before turbine (F826).
-
Hino Diagnostic eXplorer 2 – Hino DX2 1.1.19.1 with keygen unlocked ( Hino trucks )
Hino $50.00Rated 0 out of 5 -
Volvo Intermediate Storage File Encryptor/Decryptor (Editor) VISFED 0.3.2
Trucks software $35.00Rated 0 out of 5
-
Scania SDP3 2.48.6 Diagnosis & Programming for VCI 3 VCI3 without Dongle
Scania $30.00Rated 0 out of 5 -
PF Diagnose 2.0.2.23 Diagnostics Software 2013 – Full Heavy & Medium Duty with OBDII Support – Online Installation Service
PF Diagnose $60.00Rated 0 out of 5 -
PACCAR Electronic Service Analyst 5.4.3.0 SW files 27.03.2021 software trucks
PACCAR $60.00Rated 0 out of 5 -
VOLVO PREMIUM TECH TOOL PTT 2.7.116 + APCI 2021 + devtool ( ONLINE )
Trucks software $80.00Rated 0 out of 5
Related products
-
MANUAL SERVICE Deutz Combine 5650 H, 5660 HTS5670 H / HTS5680 H, 5690 HTS
DEUTZ $38.00Rated 0 out of 5 -
SERVICE MANUAL International Engines MaxxForce 7 (2007-2009)
INTERNATIONAL ENGINES $31.00Rated 0 out of 5