PACCAR MX (2004 Emissions) Fault Code: P170A Lambda – Data Valid but Too Low, Most Severe
PACCAR MX (2004 Emissions) Fault Code: P170A Lambda – Data Valid but Too Low, Most Severe
SET CONDITIONS:
The PCI ECU (D420) detects that the air/fuel ratio is too low for more than 40 seconds.
DIAGNOSTIC CONDITION:
This diagnostic runs:
1. When the engine speed is between 950 and 2000 rpm and
2. When the engine is running at a steady load and
3. When the coolant temperature is above 50°C [122°F] and
4. The engine mode is SCR high efficiency or standard or protection
5. The lambda sensor (F834) is in the operating mode (if applicable)
CORRESPONDING OBD READINESS MONITOR:
Exhaust gas sensors monitor
RESET CONDITION:
This DTC changes to inactive when the fault is no longer detected.
REPAIR VERIFICATION:
1. Clear all DTCs.
2. Test drive or operate the vehicle to meet the following conditions:
– Corresponding readiness monitor displays ‘Ready’
– Diagnostic conditions are met
– Set conditions are met
3. Did the DTC come back? (Can be pending, inactive or active)
– No, repair successful
– Yes, repair unsuccessful
POSSIBLE CAUSES:
1. Faulty fuel system
2. Faulty inlet air system
3. Lambda sensor deviation (if equipped with lambda sensor)
4. NOx sensor before catalyst deviation (only if NOT equipped with lambda sensor)
ADDITIONAL INFORMATION:
IMPORTANT: Depending on the production date of the vehicle, either the lambda sensor (F834) or the NOx sensor before catalyst (F844) is used to determine the oxygen concentration in the exhaust gas.
Typically, low air/fuel ratio indicates low oxygen concentration in the exhaust system.
-
Hino Diagnostic eXplorer 2 – Hino DX2 1.1.19.1 with keygen unlocked ( Hino trucks )
Hino $50.00Rated 0 out of 5 -
Scania SDP3 2.48.6 Diagnosis & Programming for VCI 3 VCI3 without Dongle
Scania $30.00Rated 0 out of 5
-
Wabco ToolBox plus 13.7 + ECAS CAN2 v3.00 Diagnostics Software
Trucks software $84.00Rated 0 out of 5 -
JOHN DEERE SERVICE ADVISOR 5.3.225 DATABASE AG + CF ENGLISH 2023
John Deere $250.00Rated 0 out of 5 -
10 IN 1 FOR CAT SIS Caterpillar 2021 Full Service Dealer INCLUDING CAT 2019 C
CAT $110.00Rated 0 out of 5 -
PACCAR Electronic Service Analyst 5.4.3.0 SW files 27.03.2021 software trucks
PACCAR $60.00Rated 0 out of 5 -
CLAAS WebTIC Offline [11.2021] Service Information – ENGLISH Language
CLAAS $100.00Rated 0 out of 5 -
download Hitachi Construction Machinery MPDr Ver 3.7.0.0 [10.2020] Diagnostic Software
Hitachi $76.00Rated 0 out of 5
Related products
-
SERVICE MANUAL International Engines DT466 & DT530 (2001-2003) C
INTERNATIONAL ENGINES $31.00Rated 0 out of 5 -
SERVICE MANUAL International Engines MaxxForce DT 9 10 (2007-2009)
INTERNATIONAL ENGINES $30.00Rated 0 out of 5