PACCAR MX (2004 Emissions) Fault Code: P1688 Starter Motor – Voltage Too Low or Short Circuit to Ground on ECU (D420) Pin (B16)
PACCAR MX (2004 Emissions) Fault Code: P1688 Starter Motor – Voltage Too Low or Short Circuit to Ground on ECU (D420) Pin (B16)
SET CONDITIONS:
This DTC is set when the ECU detects a lower voltage than expected on the signal or control circuit of the ECU.
DIAGNOSTIC CONDITION:
The diagnostic runs continuously when the ignition is keyed on.
CORRESPONDING OBD READINESS MONITOR:
None
RESET CONDITION:
The DTC changes to inactive after the diagnostic runs and passes.
REPAIR VERIFICATION:
1. Clear all DTCs.
2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.
3. Did the DTC come back?
– No, repair successful
– Yes, repair unsuccessful
POSSIBLE CAUSES:
1. The sensor or actuator signal wiring is interrupted.
2. The sensor or actuator signal wiring has a short circuit to ground.
3. A malfunction in the power supply of the sensor or actuator
4. A malfunction of the sensor or actuator
ADDITIONAL INFORMATION:
Multiple voltage-too-low sensor-related DTCs may indicate a malfunction within one of the 5-V sensor power supply circuits of the PCI ECU.
-
Hino Diagnostic eXplorer 2 – Hino DX2 v1.1.21.4 with keygen unlocked ( Hino trucks )
Hino $60.00Rated 0 out of 5 -
CAT ET 2021A (Caterpillar Electronic Technician) + Factory Password (1 PC )
CAT $65.00Rated 0 out of 5
-
PACCAR Electronic Service Analyst 5.4.3.0 SW files 27.03.2021 software trucks
PACCAR $60.00Rated 0 out of 5 -
CLAAS WebTIC Offline [11.2021] Service Information – ENGLISH Language
CLAAS $100.00Rated 0 out of 5 -
Wabco ToolBox plus 13.7 + ECAS CAN2 v3.00 Diagnostics Software
Trucks software $84.00Rated 0 out of 5