PACCAR MX (2004 Emissions) Fault Code: P1480 EGR Valve Module Position – Unable to Reach Target
PACCAR MX (2004 Emissions) Fault Code: P1480 EGR Valve Module Position – Unable to Reach Target
SET CONDITIONS:
The EGR valve module (L095) detects a difference between the actual shaft position and the requested shaft position for more than 5 seconds.
DIAGNOSTIC CONDITION:
This diagnostic runs continuously when the ignition is on.
CORRESPONDING OBD READINESS MONITOR:
None
RESET CONDITION:
This DTC changes to inactive after the ignition is keyed off for at least 15 seconds and keyed on again, and the fault is no longer detected.
REPAIR VERIFICATION:
1. Clear all DTCs.
2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.
3. Did the DTC come back?
– No, repair successful
– Yes, repair unsuccessful
POSSIBLE CAUSES:
1. Bent actuator lever and/or link rod
2. Sticking or blocked EGR valve or mechanism
ADDITIONAL INFORMATION:
1. The position of the actuator shaft, and therefore the position of the EGR valve, is monitored. Valve position: 0% is fully closed and 100% is fully open.
2. The actuator motor is switched off and the EGR valve is fully closed (0% position).
3. Engine torque is reduced after 10 hours of engine operation.
