PACCAR MX (2004 Emissions) Fault Code: P1409 EGR Pressure – Data Valid but Too High
PACCAR MX (2004 Emissions) Fault Code: P1409 EGR Pressure – Data Valid but Too High
SET CONDITIONS:
The PCI ECU (D420) detects that the measured boost pressure is higher than 4.5 bar [65 psi] to control the EGR gas mass flow.
DIAGNOSTIC CONDITION:
This diagnostic runs when the engine speed is above 1100 rpm.
CORRESPONDING OBD READINESS MONITOR:
None
RESET CONDITION:
This DTC changes to inactive when the fault is no longer detected.
REPAIR VERIFICATION:
1. Clear all DTCs.
2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.
3. Did the DTC come back?
– No, repair successful
– Yes, repair unsuccessful
POSSIBLE CAUSES:
Faulty turbocharger
ADDITIONAL INFORMATION:
1. The engine NOx emission is, among others, controlled by varying the EGR gas mass flow toward the inlet manifold of the engine.
2. The EGR gas mass flow is calculated using the EGR pressure difference sensor (F751) and the EGR temperature sensor (F749).
3. The boost pressure is measured by the boost pressure sensor (F802).
4. EGR gas mass flow toward the inlet manifold of the engine is controlled by the EGR valve module (L095).
IMPORTANT: The EGR valve position does not just indicate the amount of EGR flow to the inlet manifold. The amount of EGR gas fed back mainly depends on the pressure difference between the pressure before turbine and the boost pressure, in combination with the EGR valve position.