PACCAR MX (2004 Emissions) Fault Code: P1341 Camshaft Speed Signal – Out of Range During Engine Start

PACCAR MX (2004 Emissions) Fault Code: P1341 Camshaft Speed Signal – Out of Range During Engine Start

SET CONDITIONS:
The PCI ECU (D420) detects that the camshaft sensor signal is disturbed or intermittent.

DIAGNOSTIC CONDITION:
This diagnostic runs continuously when the engine is started.

CORRESPONDING OBD READINESS MONITOR:
None

RESET CONDITION:
This DTC changes to inactive when the fault is no longer detected.

REPAIR VERIFICATION:
1. Clear all DTCs.
2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.
3. Did the DTC come back?
– No, repair successful
– Yes, repair unsuccessful

POSSIBLE CAUSES:
1. Faulty camshaft sensor signal
2. Faulty camshaft sensor

ADDITIONAL INFORMATION:
1. Camshaft sensor (F558) is used to determine the position of the engine (cylinder detection).
2. Engine torque is reduced.