PACCAR MX (2004 Emissions) Fault Code: P1208 Injector Solenoid Valve Cylinder 5 – Voltage Too High or Short Circuit to Supply on ECU (D420) Pin (A4)
PACCAR MX (2004 Emissions) Fault Code: P1208 Injector Solenoid Valve Cylinder 5 – Voltage Too High or Short Circuit to Supply on ECU (D420) Pin (A4)
SET CONDITIONS:
The PCI ECU (D420) detects a too high voltage or a short circuit to supply on the ECU pin A4 circuit.
DIAGNOSTIC CONDITION:
This diagnostic runs when the engine is running.
CORRESPONDING OBD READINESS MONITOR:
None
RESET CONDITION:
This DTC changes to inactive when the fault is no longer detected. To enable the injector output, the DTC must be cleared.
REPAIR VERIFICATION:
1. Clear all DTCs.
2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.
3. Did the DTC come back?
– No, repair successful
– Yes, repair unsuccessful
POSSIBLE CAUSES:
Short circuit to supply in the circuit of ECU pin A4
ADDITIONAL INFORMATION:
The injector output is disabled by the PCI ECU when this DTC is detected. The output stays disabled until the DTC is cleared.
Related
-
International Truck ISIS – Oncommand Service Information Q4.2020 [04.2020]
Navistar $85.00Rated 0 out of 5 -
CAT CDVR PC Software – Caterpillar Digital Voltage Regulator (CDVR) WINDOWS 10
CAT $45.00Rated 0 out of 5
Related products
-
SERVICE MANUAL International Engines DT466 & DT530 (2001-2003) C
INTERNATIONAL ENGINES $31.00Rated 0 out of 5