PACCAR MX (2004 Emissions) Fault Code: P1205 Injector Solenoid Valve Cylinder 5 – Current Too Low or Open Circuit on ECU (D420) Pin (A3) and or Pin (A4)
PACCAR MX (2004 Emissions) Fault Code: P1205 Injector Solenoid Valve Cylinder 5 – Current Too Low or Open Circuit on ECU (D420) Pin (A3) and or Pin (A4)
SET CONDITIONS:
The PCI ECU (D420) detects no or a too low current in the electrical circuit of the injector.
DIAGNOSTIC CONDITION:
This diagnostic runs when the engine is running.
CORRESPONDING OBD READINESS MONITOR:
None
RESET CONDITION:
1. This DTC changes to inactive when the fault is no longer detected.
2. To enable the injector output, the ignition must be shut off for more the 15 seconds and turned on again.
REPAIR VERIFICATION:
1. Clear all DTCs.
2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.
3. Did the DTC come back?
– No, repair successful
– Yes, repair unsuccessful
POSSIBLE CAUSES:
1. Open circuit in the wiring of the wiring loom frame (valve cover)
2. Faulty injector
3. Engine wiring harness
ADDITIONAL INFORMATION:
The injector output is disabled by the PCI ECU when this DTC is detected.
-
Hino Diagnostic eXplorer 2 – Hino DX2 1.1.19.1 with keygen unlocked ( Hino trucks )
Hino $50.00Rated 0 out of 5 -
download Hitachi Construction Machinery MPDr Ver 3.7.0.0 [10.2020] Diagnostic Software
Hitachi $76.00Rated 0 out of 5
-
Navistar international OnCommand service information 2018 software trucks
Navistar $50.00Rated 0 out of 5 -
JPRO 2022 v1 Commercial Vehicle Diagnostics V1 Software Download & Installation Service ( 1 PC )
JPRO $94.00Rated 0 out of 5 -
John Deere & Hitachi Parts ADVISOR 2020 [08.2020] Offline DVD Spare Parts Catalog
John Deere $120.00Rated 0 out of 5 -
CAT Engine Reprogramming Tool for flash programming C1.8, C2.4, C3.8 & C3.3B + Guide
CAT $50.00Rated 0 out of 5 -
Bobcat Service Library [03.2019] Service, Operator, Maintenance, Bulletines, etc full update
Bobcat $110.00Rated 0 out of 5