PACCAR MX (2004 Emissions) Fault Code: P1201 Injector Solenoid Valve Cylinder 1 – Current Too Low or Open Circuit on ECU (D420) Pin and or Pin (A2)
PACCAR MX (2004 Emissions) Fault Code: P1201 Injector Solenoid Valve Cylinder 1 – Current Too Low or Open Circuit on ECU (D420) Pin and or Pin (A2)
SET CONDITIONS:
The PCI ECU (D420) detects no or a too low current in the electrical circuit of the injector.
DIAGNOSTIC CONDITION:
This diagnostic runs when the engine is running.
CORRESPONDING OBD READINESS MONITOR:
None
RESET CONDITION:
1. This DTC changes to inactive when the fault is no longer detected.
2. To enable the injector output, the ignition must be shut off for more the 15 seconds and turned on again.
REPAIR VERIFICATION:
1. Clear all DTCs.
2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.
3. Did the DTC come back?
– No, repair successful
– Yes, repair unsuccessful
POSSIBLE CAUSES:
1. Open circuit in the wiring of the wiring loom frame (valve cover)
2. Faulty injector
3. Engine wiring harness
ADDITIONAL INFORMATION:
The injector output is disabled by the PCI ECU when this DTC is detected.
-
2021 VOLVO PREMIUM TECH TOOL PTT V2.8.21 VCADS+DEVELOPER TOOL+APCI 2021/09 ( 1 PC )
Trucks software $85.00Rated 0 out of 5 -
VOLVO PREMIUM TECH TOOL PTT 2.7.116 + APCI 2021 + devtool ( ONLINE )
Trucks software $80.00Rated 0 out of 5 -
Volvo Premium Tech Tool PTT 2.8.130 Diagnostic Software 04.2022 ACPI ( 1 PC )
Trucks software $143.00Rated 0 out of 5 -
JPRO 2022 v1 Commercial Vehicle Diagnostics V1 Software Download & Installation Service ( 1 PC )
JPRO $94.00Rated 0 out of 5 -
Scania SDP3 2.48.6 Diagnosis & Programming for VCI 3 VCI3 without Dongle
Scania $30.00Rated 0 out of 5
Related products
-
SERVICE MANUAL International Engines MaxxForce 11 & 13 (2014 & Newer)
INTERNATIONAL ENGINES $20.00Rated 0 out of 5