PACCAR MX (2004 Emissions) Fault Code: P1137 Lambda Sensor Heater Power Supply – Incorrect
PACCAR MX (2004 Emissions) Fault Code: P1137 Lambda Sensor Heater Power Supply – Incorrect
SET CONDITIONS:
The PCI ECU (D420) detects that the power supply to control the lambda sensor heater is less than 9 V for more than five seconds.
DIAGNOSTIC CONDITION:
This diagnostic runs continuously when the engine is running.
RESET CONDITION:
This DTC changes to inactive when the fault is no longer detected.
POSSIBLE CAUSES:
Power supply to the PCI ECU
ADDITIONAL INFORMATION:
The PCI ECU uses the oxygen concentration in the exhaust measured by the lambda sensor (F834) to determine the air/fuel ratio of the combustion process. The sensor has an integrated heater to maintain a sensor operating temperature of approximately 750?C [1382?F].
-
CAT ET 2021A (Caterpillar Electronic Technician) + Factory Password (1 PC )
CAT $65.00Rated 0 out of 5 -
JPRO 2022 v1 Commercial Vehicle Diagnostics V1 Software Download & Installation Service ( 1 PC )
JPRO $94.00Rated 0 out of 5
-
Volvo PROSIS Offline 2019 Parts Catalog Installation Service
Trucks software $45.00Rated 0 out of 5 -
CAT ET 2021A (Caterpillar Electronic Technician) + Factory Password (1 PC )
CAT $65.00Rated 0 out of 5 -
DOWNLOAD Paccar ESA Electronic Service Analyst 5.5.0 Diagnostic Software 2023
PACCAR $96.00Rated 0 out of 5
Related products
-
SERVICE MANUAL International Engines MaxxForce 7 (2007-2009)
INTERNATIONAL ENGINES $31.00Rated 0 out of 5