PACCAR MX (2004 Emissions) Fault Code: P1135 Lambda Sensor Heater – Voltage Too High or Short Circuit to Supply on ECU (D420) Pin (C46)
PACCAR MX (2004 Emissions) Fault Code: P1135 Lambda Sensor Heater – Voltage Too High or Short Circuit to Supply on ECU (D420) Pin (C46)
SET CONDITIONS:
This DTC is set when the ECU detects a higher voltage than expected on the signal or control circuit of the ECU.
DIAGNOSTIC CONDITION:
The diagnostic runs continuously when the ignition is keyed on.
RESET CONDITION:
The DTC changes to inactive after the diagnostic runs and passes.
POSSIBLE CAUSES:
1. The sensor or actuator signal wiring has a short circuit to supply.
2. A malfunction of the sensor or actuator
-
Scania SDP3 2.48.6 Diagnosis & Programming for VCI 3 VCI3 without Dongle
Scania $30.00Rated 0 out of 5 -
CAT Engine Reprogramming Tool for flash programming C1.8, C2.4, C3.8 & C3.3B + Guide
CAT $50.00Rated 0 out of 5
Related products
-
SERVICE MANUAL International Engines MaxxForce DT 9 10 (2010-2013)
INTERNATIONAL ENGINES $20.00Rated 0 out of 5