PACCAR MX (2004 Emissions) Fault Code: P1089 Common Rail Fuel Pressure – Data Valid but Too High
PACCAR MX (2004 Emissions) Fault Code: P1089 Common Rail Fuel Pressure – Data Valid but Too High
SET CONDITIONS:
The PCI ECU (D420) detects that the measured rail pressure is more than 2840 bar [41191 psi].
DIAGNOSTIC CONDITION:
This diagnostic runs when the rail pressure operating state is: Pump unit only or Rail discharge.
CORRESPONDING OBD READINESS MONITOR:
None
RESET CONDITION:
This DTC changes to inactive when the fault is no longer detected.
REPAIR VERIFICATION:
1. Clear all DTCs.
2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.
3. Did the DTC come back?
– No, repair successful
– Yes, repair unsuccessful
POSSIBLE CAUSES:
Faulty common rail pump unit
ADDITIONAL INFORMATION:
1. The rail pressure is measured in the common rail by the common rail pressure sensor (F854).
2. When this DTC is active:
– The engine torque is reduced.
– The engine runs in protection mode.
– The engine runs in rail pressure control state: Release valve only.
– The maximum rail pressure is limited to 1300 bar.
-
Eaton Service Ranger 4.9 Engineering 4.9 [05.2021] Engineering Level ( 1 PC )
Eaton $67.00Rated 0 out of 5
-
DETROIT DDDL 8.14 SP3 – Detroit Diesel Diagnostic Link 8.14 SP3 2021 ( 1PC )
Detroit $73.00Rated 0 out of 5 -
JPRO 2022 v1 Commercial Vehicle Diagnostics V1 Software Download & Installation Service ( 1 PC )
JPRO $94.00Rated 0 out of 5 -
Eaton Service Ranger 4.9 Engineering 4.9 [05.2021] Engineering Level ( 1 PC )
Eaton $67.00Rated 0 out of 5 -
DOWNLOAD NISSAN UD DIESEL PC-CONSULT DIAGNOSTIC 1.1.13 & PC-REPROMASTER 1.2.0
NISSAN UD $100.00Rated 0 out of 5 -
DPF EGR SCR BAC ERG Delete & Flash CAAT Cummings Detroit Dodge Mack Volvo Collection of DELETE files
CAT $200.00Rated 0 out of 5
Related products
-
SERVICE MANUAL International Engines MaxxForce 7 (2010 & Newer)
INTERNATIONAL ENGINES $34.00Rated 0 out of 5