PACCAR MX (2004 Emissions) Fault Code: P062D Internal ECU Injector Power Generation – Voltage Too Low
PACCAR MX (2004 Emissions) Fault Code: P062D Internal ECU Injector Power Generation – Voltage Too Low
SET CONDITIONS:
The internal ECU injector power supply voltage is too low.
DIAGNOSTIC CONDITION:
This diagnostic runs continuously when the ignition is on.
CORRESPONDING OBD READINESS MONITOR:
None
RESET CONDITION:
This DTC changes to inactive when the fault is no longer detected.
REPAIR VERIFICATION:
1. Clear all DTCs.
2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.
3. Did the DTC come back?
– No, repair successful
– Yes, repair unsuccessful
POSSIBLE CAUSES:
Clear the fault with the diagnostic service tool. If the fault reoccurs after ignition on, replace the ECU.
ADDITIONAL INFORMATION:
1. Numerous OBD monitors will not run anymore.
2. Humidity calculation and correction switched off.
![DOOSAN DMS-5 3.1.3 [2023.11] diagnostic software](https://www.ecuforcetruck.com/wp-content/uploads/2023/11/1-300x300.png)
