PACCAR MX (2004 Emissions) Fault Code: P0562 PCI ECU Power Supply – Data Valid but Too Low on ECU (D420) Pin (B60) or Pin (B61) or Pin (B62)
PACCAR MX (2004 Emissions) Fault Code: P0562 PCI ECU Power Supply – Data Valid but Too Low on ECU (D420) Pin (B60) or Pin (B61) or Pin (B62)
SET CONDITIONS:
The ECU power supply voltage is too low.
DIAGNOSTIC CONDITION:
This diagnostic runs continuously when the ignition is on.
CORRESPONDING OBD READINESS MONITOR:
None
RESET CONDITION:
This DTC changes to inactive when the fault is no longer detected.
REPAIR VERIFICATION:
1. Clear all DTCs.
2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.
3. Did the DTC come back?
– No, repair successful
– Yes, repair unsuccessful
POSSIBLE CAUSES:
Check the power supply level
ADDITIONAL INFORMATION:
Numerous diagnostics will not run anymore.
-
CLAAS WebTIC Offline [11.2021] Service Information – ENGLISH Language
CLAAS $100.00Rated 0 out of 5
-
Eaton Service Ranger 4.9 Engineering 4.9 [05.2021] Engineering Level ( 1 PC )
Eaton $67.00Rated 0 out of 5 -
International Truck ISIS – Oncommand Service Information Q4.2020 [04.2020]
Navistar $85.00Rated 0 out of 5
Related products
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0562 System Voltage Low
1000 & 2000 Gen 4 $50.00Rated 0 out of 5
-
SERVICE MANUAL DETROIT DIESEL EPA 07, EPA 10, GHG 14 TROUBLESHOOTING
DETROIT $38.00Rated 0 out of 5