PACCAR MX (2004 Emissions) Fault Code: P0340 Camshaft Speed Signal – Disturbed or no Signal During Engine Operation
PACCAR MX (2004 Emissions) Fault Code: P0340 Camshaft Speed Signal – Disturbed or no Signal During Engine Operation
SET CONDITIONS:
The PCI ECU (D420) detects that one or more teeth of the camshaft sensor tone wheel are not detected within one crankshaft revolution.
DIAGNOSTIC CONDITION:
This diagnostic runs continuously when the engine is running.
CORRESPONDING OBD READINESS MONITOR:
None
RESET CONDITION:
This DTC changes to inactive when the fault is no longer detected.
REPAIR VERIFICATION:
1. Clear all DTCs.
2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.
3. Did the DTC come back?
– No, repair successful
– Yes, repair unsuccessful
POSSIBLE CAUSES:
1. No camshaft sensor signal
2. Faulty camshaft sensor signal
3. Damaged pulse ring
ADDITIONAL INFORMATION:
1. Camshaft sensor (F558) is used to determine the position of the engine (cylinder detection).
2. Engine torque is reduced.
-
10 IN 1 FOR CAT SIS Caterpillar 2021 Full Service Dealer INCLUDING CAT 2019 C
CAT $110.00Rated 0 out of 5 -
CAT ET 2021A (Caterpillar Electronic Technician) + Factory Password (1 PC )
CAT $65.00Rated 0 out of 5
-
CAT Engine Reprogramming Tool for flash programming C1.8, C2.4, C3.8 & C3.3B + Guide
CAT $50.00Rated 0 out of 5 -
PACCAR Electronic Service Analyst 5.4.3.0 SW files 27.03.2021 software trucks
PACCAR $60.00Rated 0 out of 5