PACCAR MX (2004 Emissions) Fault Code: P0315 Cylinder Unbalance – Detected
PACCAR MX (2004 Emissions) Fault Code: P0315 Cylinder Unbalance – Detected
SET CONDITIONS:
The PCI ECU (D420) detects an imbalance for more than 500 crankshaft revolutions.
DIAGNOSTIC CONDITION:
This diagnostic runs 30 seconds after the engine has started and when the engine is running at a steady speed and load between 600 and 1900 rpm.
RESET CONDITION:
This DTC changes to inactive when the fault is no longer detected. To validate the repair, drive the vehicle until the coolant temperature is at least 70°C [158°F]. Once the minimum target temperature has been reached, perform several low to higher speed accelerations with moderate engine load. Also perform high-load to low-load transitions. This activity should be conducted within the range of 15 km/h [10 mph] to 65 km/h [40 mph] for no more than 5 to 8 km [3 to 5 miles].
POSSIBLE CAUSES:
1. Fuel injector failure
2. Mechanical engine failure
3. Damaged flywheel holes
ADDITIONAL INFORMATION:
The detection of cylinder misfiring is based on piston acceleration, converted to crankshaft acceleration, which is directly related to the amount of torque that a cylinder produces. To determine crankshaft acceleration, several measurements are performed by the crankshaft sensor (F552) signal.
-
Hino Diagnostic eXplorer 2 – Hino DX2 v1.1.21.4 with keygen unlocked ( Hino trucks )
Hino $60.00Rated 0 out of 5 -
PF Diagnose 2.0.2.23 Diagnostics Software 2013 – Full Heavy & Medium Duty with OBDII Support – Online Installation Service
PF Diagnose $60.00Rated 0 out of 5
-
DETROIT DDDL 8.14 SP3 – Detroit Diesel Diagnostic Link 8.14 SP3 2021 ( 1PC )
Detroit $73.00Rated 0 out of 5 -
CAT Engine Reprogramming Tool for flash programming C1.8, C2.4, C3.8 & C3.3B + Guide
CAT $50.00Rated 0 out of 5 -
Wabco ToolBox plus 13.7.0.1 + ECAS CAN2 v3.00 Diagnostics Software
Trucks software $84.00Rated 0 out of 5