PACCAR MX (2004 Emissions) Fault Code: P0315 Cylinder Unbalance – Detected
PACCAR MX (2004 Emissions) Fault Code: P0315 Cylinder Unbalance – Detected
SET CONDITIONS:
The PCI ECU (D420) detects an imbalance for more than 500 crankshaft revolutions.
DIAGNOSTIC CONDITION:
This diagnostic runs 30 seconds after the engine has started and when the engine is running at a steady speed and load between 600 and 1900 rpm.
RESET CONDITION:
This DTC changes to inactive when the fault is no longer detected. To validate the repair, drive the vehicle until the coolant temperature is at least 70°C [158°F]. Once the minimum target temperature has been reached, perform several low to higher speed accelerations with moderate engine load. Also perform high-load to low-load transitions. This activity should be conducted within the range of 15 km/h [10 mph] to 65 km/h [40 mph] for no more than 5 to 8 km [3 to 5 miles].
POSSIBLE CAUSES:
1. Fuel injector failure
2. Mechanical engine failure
3. Damaged flywheel holes
ADDITIONAL INFORMATION:
The detection of cylinder misfiring is based on piston acceleration, converted to crankshaft acceleration, which is directly related to the amount of torque that a cylinder produces. To determine crankshaft acceleration, several measurements are performed by the crankshaft sensor (F552) signal.
-
Volvo PROSIS Offline 2019 Parts Catalog Installation Service
Trucks software $45.00Rated 0 out of 5 -
Wabco ToolBox plus 13.7.0.1 + ECAS CAN2 v3.00 Diagnostics Software
Trucks software $84.00Rated 0 out of 5 -
Scania SDP3 2.48.6 Diagnosis & Programming for VCI 3 VCI3 without Dongle
Scania $30.00Rated 0 out of 5
Related products
-
SERVICE MANUAL Carrie Genesis R70 Genesis R90 Genesis TR1000 Multi -Temp
CARRIE $25.00Rated 0 out of 5 -
SERVICE MANUAL International Engines MaxxForce 7 (2007-2009)
INTERNATIONAL ENGINES $31.00Rated 0 out of 5 -
SERVICE MANUAL International Engines DT466 & DT530 (2001-2003) C
INTERNATIONAL ENGINES $31.00Rated 0 out of 5