PACCAR MX (2004 Emissions) Fault Code: P0306 Cylinder 6 – Contribution Too Low or Misfire
PACCAR MX (2004 Emissions) Fault Code: P0306 Cylinder 6 – Contribution Too Low or Misfire
SET CONDITIONS:
The PCI ECU (D420) detects that cylinder 6 is misfiring or the combustion contribution is lower relative to the other cylinders.
DIAGNOSTIC CONDITION:
This diagnostic runs when the engine is running at a steady speed and load, and the vehicle speed is steady.
CORRESPONDING OBD READINESS MONITOR:
Misfire monitor
RESET CONDITION:
This DTC changes to inactive when the fault is no longer detected.
REPAIR VERIFICATION:
1. Clear all DTCs.
2. Test drive or operate the vehicle to meet the following conditions:
– Corresponding readiness monitor displays ‘Ready’
– Diagnostic conditions are met
– Set conditions are met
3. Did the DTC come back?
– No, repair successful
– Yes, repair unsuccessful
POSSIBLE CAUSES:
1. Faulty cylinder 6 injector (not fueling or under-fueling)
2. Loose cylinder 6 injector
3. Faulty MX Engine Brake cylinder 6
4. Symptom: Slightly reduced power:
– Incorrect valve clearance
– Large imbalance in the drive shaft
5. Symptom: Engine block vibration at high load, damaged flywheel
6. Mechanical defect (for example damaged cam follower or broken valve)
ADDITIONAL INFORMATION:
The PCI ECU can detect and identify the cylinder contribution of every cylinder based on analysis of the rotational speed of the crankshaft using a:
1. Cylinder-to-cylinder engine speed comparison and
2. A cylinder-to-cylinder rotational crankshaft acceleration comparison
