PACCAR MX (2004 Emissions) Fault Code: P006B Exhaust Gas Pressure After BPV – Data Erratic, Intermittent or Incorrect, at Ignition On
PACCAR MX (2004 Emissions) Fault Code: P006B Exhaust Gas Pressure After BPV – Data Erratic, Intermittent or Incorrect, at Ignition On
SET CONDITIONS:
The PCI ECU (D420) detects that the measured pressure after BPV differs more than 0.07 bar [1 PSI] from the average of other engine pressure sensor readings for more than five seconds.
DIAGNOSTIC CONDITION:
This diagnostic runs:
1. When the ignition is keyed on (NO engine start), and
2. Ambient temperature is more than -20°C [-4°F]
CORRESPONDING OBD READINESS MONITOR:
None
RESET CONDITION:
This DTC changes to inactive when the fault is no longer detected.
REPAIR VERIFICATION:
1. Clear all DTCs.
2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.
3. Did the DTC come back? (Can be pending, inactive or active)
– No, repair successful
– Yes, repair unsuccessful
POSSIBLE CAUSES:
Pressure sensor after BPV deviation
ADDITIONAL INFORMATION:
For this diagnostic, the pressure sensor after BPV (F823) reading is compared with an average of other engine pressure sensor readings.
