Eaton Gen 2 (AutoShift) Fault Code: 73 PID: SID 58 FMI: 7 Failed to Engage Gear
Overview:
Fault Code 73 indicates the transmission is unable to engage the desired gear in the front box during a shift.
Detection:
The transmission detects this fault by attempting the same shifter action 5 times and not sensing the desired position.
Fallback:
This fault causes an in-place fallback.
Possible Causes:
1) Electric Shifter
2) Yoke, Clutch, Main Shaft
3) Gear Select Sensor
4) Shift Block
Shop Talk:
Complete several shifts while the vehicle is in motion, including selections from neutral. Also allow the transmission to complete several automatic
shifts.
Related products
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P1688 Unmanaged Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0848 Transmission Pressure Switch Solenoid D Circuit High
1000 & 2000 Gen 4 $50.00 -
-
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1096 J1850 (Class 2) IPC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0876 Transmission Reverse Pressure Switch Circuit Stuck Open
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P2771 Four-Wheel Drive Switch Circuit
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1064 J1850 (Class 2) TBC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
