Eaton Gen 2 (AutoShift) Fault Code: 27 PID: SID 55 FMI: 7 Clutch Disengagement
Overview:
Fault Code 27 indicates the clutch has not disengaged as expected.
Detection:
1) Starting at key on and throughout operation, the Shift Controller
constantly measures engine RPM and idle torque from the engine.
2) When engaging a start gear, if the engine speed falls significantly
below idle or engine torque rises significantly above idle torque the fault is set.
3) If in gear and the vehicle is brought to a stop and engine speed falls significantly below idle, the fault is set.
Fallback:
There is no fallback associated with this failure; however, it may be difficult to achieve gear engagement or disengagement
Possible Causes:
1) Worn or broken clutch
Shop Talk:
Operate the vehicle. If the fault is present, the system should automatically detect the problem and set the code. If the fault is not present, operate the vehicle and attempt to duplicate the driving conditions that triggered the fault code. Possible triggers include heat, vibration and aggressive stops.
Related products
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U0031 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0123 Pedal Position Sensor Circuit High Voltage
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0873 Transmission Pressure Switch Solenoid E Circuit High
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0218 Transmission Fluid Over Temperature Condition
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P1688 Unmanaged Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1096 J1850 (Class 2) IPC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
