Eaton Fuller Advantage (2017) Fault Code: 75 PID: SID 60 SPN: FMI: 14 Power Down in Gear: Special Instructions
Overview:
The Fuller Advantage Transmission Electronic Control Unit (TECU) monitors gear and rail position sensors to determine the position of the X-Y Shifter Shift Finger. Fault Code 75 indicates the transmission was powered down with the Shift Finger in a non-neutral gear position.
Detection:
Ignition key is turned off with the X-Y Shifter Shift Finger in a non-neutral position.
Conditions to Set Fault Code Active:
FMI 14 – Special Instructions: TECU detects a non-neutral gear position during power down.
Fallback:
No fallback mode is associated with this fault.
Conditions to Set Fault Code Inactive:
FMI 14: Fault code sets Inactive upon the next power-up cycle.
Possible Causes:
FMI 14
1) Driver Behavior
– Driver turned the ignition off with the transmission in a non-neutral state
2) Vehicle Ignition Supply
– Unintentional loss of ignition supply to TECU
Component Identification:
None
Related products
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1096 J1850 (Class 2) IPC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1000 Class 2 Loss of Serial Data Communication
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0848 Transmission Pressure Switch Solenoid D Circuit High
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1041 J1850 (Class 2) ABS Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2771 Four-Wheel Drive Switch Circuit
1000 & 2000 Gen 4 $50.00 -
-
Bendix ABS EC-30 Fault Code: SID 251 FMI 3
Bendix ABS -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U0031 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
