Detroit DD16 GHG14 (2014-16) Fault Code: SPN 636 FMI 14 (MCM) Swapped Pins
NOTE: If the sensor is removed, be sure to check the sensor tip for metal debris and clutch material and clean it if necessary.
NOTE: If this SPN and FMI are active, verify that the wiring from crankshaft position (CKP) sensor pin 1 to pin 73 of the motor control module (MCM) 120-pin connector and that the wiring from CKP sensor pin 2 pin of the MCM 120 – pin connector is correct.
PROBABLE CAUSES:
1. Crankshaft sensor connector/harness.
2. Crankshaft sensor.
3. Swapped pins on the connector.
Related products
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1064 J1850 (Class 2) TBC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1000 Class 2 Loss of Serial Data Communication
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0876 Transmission Reverse Pressure Switch Circuit Stuck Open
1000 & 2000 Gen 4 $50.00 -
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0218 Transmission Fluid Over Temperature Condition
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1300 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0870 Transmission Pressure Switch Solenoid E Circuit
1000 & 2000 Gen 4 $50.00 -
