Detroit DD16 GHG14 (2014-16) Fault Code: SPN 5435 FMI 7 (ACM) Non Diesel Exhaust Fluid Flow Situation
NOTE: This code sets when the aftertreatment control module (ACM) detects that the diesel exhaust fluid (DEF) pump speed is too low when activated.
DESCRIPTION:
Non DEF flow situation.
MONITORED PARAMETER:
DEF pump speed.
TYPICAL ENABLING CONDITIONS:
DEF pump enabled and cannot operate above a DEF pump speed threshold.
MONITOR SEQUENCE:
DEF pump is enabled.
EXECUTION FREQUENCY:
Service tool and infrequent in-use checks during on DEF dosing conditions.
TYPICAL DURATION:
Two seconds
DASH LAMPS:
1. MIL
2. CEL
ENGINE REACTION:
Derate 25%
VERIFICATION:
Selective catalyst reduction airless dosing system (SCR ADS) self-check.
NOTE: If codes 4374-3, 4374-4, or 4374-5 are active, fix those first.
PROBABLE CAUSES:
1. Inspect the DEF pump harness wiring & connector.
2. Failed DEF pump.
Related products
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0122 Pedal Position Sensor Circuit Low Voltage
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1301 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U0031 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P2771 Four-Wheel Drive Switch Circuit
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P1688 Unmanaged Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0848 Transmission Pressure Switch Solenoid D Circuit High
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1000 Class 2 Loss of Serial Data Communication
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0123 Pedal Position Sensor Circuit High Voltage
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1064 J1850 (Class 2) TBC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
-
