Detroit DD16 EPA10 (2010-13) Fault Code: SPN 630 FMI 14 (CPC) Communication Interruption Between the Common Powertrain Controller and Motor Control Module
POSSIBLE CAUSES:
1. Diagnostic service tool connection to the CPC/MCM at a specific time within the first few seconds of ignition on, and remaining connected for over 10 minutes.
2. Sending parameters to the CPC while connected to both the CPC and MCM and the diagnostic service tool remaining connected for over 10 minutes.
NOTE: The only required action is to disconnect the diagnostic service tool.
NOTE: The only solution is to disconnect the diagnostic software and re-connect.
Related products
-
Allison 1000 & 2000 Gen 4 Fault Codes: U0032 J1850 (Class 2) Serial Data Communication Link High
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0848 Transmission Pressure Switch Solenoid D Circuit High
1000 & 2000 Gen 4 $50.00 -
-
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0873 Transmission Pressure Switch Solenoid E Circuit High
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1064 J1850 (Class 2) TBC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P1688 Unmanaged Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
-
Bendix ABS EC-30 Fault Code: SID 251 FMI 3
Bendix ABS -
Allison 1000 & 2000 Gen 4 Fault Codes: U1300 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0876 Transmission Reverse Pressure Switch Circuit Stuck Open
1000 & 2000 Gen 4 $50.00
