Detroit DD16 EPA10 (2010-13) Fault Code: SPN 615 FMI 14 (MCM) Internal or External Leakage of the High Pressure Fuel System
NOTE: The motor control module (MCM) monitors the rail pressure and when a leakage rate is greater than 150 1/h, the MCM sets the code. There is no fault reaction (limp home mode) associated to this code.
POSSIBLE CAUSES:
1. External fuel leakage between the high pressure pump and fuel injectors.
2. High pressure pump (pumping elements).
3. Fuel injector (amplifier or needle) leakage.
4. Pressure limiting valve leakage (internal).
NOTE: The MCM monitors the rail pressure and when a leakage rate is greater than 150 l/h this code is set.
PROBABLE CAUSES:
1. External fuel leakage between the high pressure pump and fuel injectors.
2. High pressure pump.
3. Fuel injector leakage.
4. Pressure limiting valve leakage (internal).
Related products
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1301 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1096 J1850 (Class 2) IPC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1000 Class 2 Loss of Serial Data Communication
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U0031 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1300 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2771 Four-Wheel Drive Switch Circuit
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0218 Transmission Fluid Over Temperature Condition
1000 & 2000 Gen 4 $50.00
