Facebook-f Twitter Github Bitbucket
Shop
Account
Cart $0.00
0
0
Subtotal: $0.00
No products in the cart.

Detroit DD16 EPA10 (2010-13) Fault Code: SPN 3510 FMI 4 (ACM) Aftertreatment Control Module 2 Sensor Supply 2 Short to Ground

DESCRIPTION:
5V sensor supply bank 2 circuit failed low.

MONITORED PARAMETER:
Motor Control Module (MCM) 5V internal power supply.

TYPICAL ENABLING CONDITIONS:
Always enabled

MONITOR SEQUENCE:
None

EXECUTION FREQUENCY:
Always enabled

TYPICAL DURATION:
Two seconds

DASH LAMPS:
1. MIL
2. CEL

ENGINE REACTION:
None

VERIFICATION:
Engine Idle (1 minute).

NOTE: Disconnect one sensor at a time.

PROBABLE CAUSES:
When code goes inactive, that is the sensor that has failed:
1. Fuel line pressure sensor.
2. Fuel compensation pressure sensor.
3. Engine oil pressure sensor.
4. Inlet manifold pressure/temperature sensor.
5. DPF inlet pressure sensor.
6. DPF outlet pressure sensor.
7. Intake throttle valve.
8. Camshaft position sensor.

NOTE: If none go inactive, disconnect the 31-pin connector on left side of the engine. If code goes inactive, replace the DPF pressure sensor.

NOTE: If you disconnect the 120-pin ECM connection and the code is still active, replace the MCM.

Categories , , Tags , , , , , , , , , , , , , , , , , , , ,
Facebook Twitter Youtube
Wiring Diagrams
Component Locators

Related products