Detroit DD16 EPA10 (2010-13) Fault Code: SPN 3480 FMI 0 (MCM) Fuel Compensation Pressure High
DESCRIPTION:
This fault will become active once the fuel compensation pressure reaches and stays above 599 kPa (87 psi) for GEN1 fuel system, or 799 kPa(116 psi) for GEN2 fuel system, for longer than 600 seconds during a driving regen, or 60 seconds during a parked regeneration with all conditions met.
MONITORED PARAMETER:
Doser fuel line pressure.
TYPICAL ENABLING CONDITIONS:
Dosing enabled
MONITOR SEQUENCE:
None
EXECUTION FREQUENCY:
Continuous when enabling conditions met.
TYPICAL DURATION:
One minute
DASH LAMPS:
1. MIL
2. CEL
ENGINE REACTION:
1. Derate 10%.
2. DPF inhibit regeneration.
VERIFICATION:
Parked regeneration
NOTE: If any other codes are active, fix those first.
PROBABLE CAUSES:
1. HC doser or fuel doser injector valve fuel lines are blocked or leaking.
2. Low pressure fuel out of spec (10-65 psi).
3. Fuel compensation pressure sensor.
4. Perform parked regen.
![DOOSAN DMS-5 3.1.3 [2023.11] diagnostic software](https://www.ecuforcetruck.com/wp-content/uploads/2023/11/1-300x300.png)
Related products
-
Bendix ABS EC-30 Fault Code: SID 251 FMI 3
Bendix ABS -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1301 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0876 Transmission Reverse Pressure Switch Circuit Stuck Open
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P1779 Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P2771 Four-Wheel Drive Switch Circuit
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1300 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0122 Pedal Position Sensor Circuit Low Voltage
1000 & 2000 Gen 4 $50.00 -
-
-
-
