Detroit DD16 EPA10 (2010-13) Fault Code: SPN 157 FMI 18 (MCM) Fuel Rail Pressure Too High
DESCRIPTION:
Fuel rail pressure too high.
MONITORED PARAMETER:
Fuel rail pressure
TYPICAL ENABLING CONDITIONS:
Closed loop and actual RP greater than 200 bar of desired RP.
MONITOR SEQUENCE:
None
EXECUTION FREQUENCY:
Continuous when enabling conditions met.
TYPICAL DURATION:
8 seconds
DASH LAMPS:
1. MIL
2. CEL
ENGINE REACTION:
Derate 25%
VERIFICATION:
Steady engine 1400-1500 rpm: Two minutes.
NOTE: The motor control module (MCM) monitors the fuel rail pressure, and when fuel rail pressure deviation is greater than 200 bar higher than requested fuel rail pressure for eight seconds, the MCM sets the code.
POSSIBLE CAUSES:
1. Faulty fuel rail pressure sensor.
2. Faulty quantity control valve (QCV).
3. Faulty MCM.
4. Faulty wiring.
NOTE: The ECM monitors the rail pressure and when it changes more than 200 bar for 8 seconds the code is set.
PROBABLE CAUSES:
1. Fuel rail pressure sensor connector/harness.
2. Fuel rail pressure sensor.
3. Failed Quantity Control Valve.
4. Failed ECM.
Related products
-
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U0031 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1041 J1850 (Class 2) ABS Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1096 J1850 (Class 2) IPC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
Bendix ABS EC-30 Fault Code: SID 251 FMI 3
Bendix ABS -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P1688 Unmanaged Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1064 J1850 (Class 2) TBC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0218 Transmission Fluid Over Temperature Condition
1000 & 2000 Gen 4 $50.00 -
-
-
