Detroit DD16 EPA07 (2007-09) Fault Code: SPN 1663 FMI 7 (MCM, CPC, ACM) Optimized Idle Safety Loop Faulted
DESCRIPTION:
Optimized idle safety loop faulted.
MONITORED PARAMETER:
Optimized idle safety loop (parking brake, hood tilt switch, neutral safety switch and vehicle speed).
TYPICAL ENABLING CONDITIONS:
Fault is set active is a maximum number of vehicle speed sensor pulses during and optimized idle engine start is exceeded or the vehicle speed is above 0.25 km/h or the engine torque is above a calibrated threshold for 2 seconds.
MONITOR SEQUENCE:
None
DASH LAMPS:
CEL
ENGINE REACTION:
None
VERIFICATION:
Run an optimized idle mode.
NOTE: Vehicle speed sensor failure.
![download Hitachi Construction Machinery MPDr Ver 3.7.0.0 [10.2020] Diagnostic Software](https://www.ecuforcetruck.com/wp-content/uploads/2023/05/MPDR-3.7.00-300x300.png)
Related products
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0848 Transmission Pressure Switch Solenoid D Circuit High
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0123 Pedal Position Sensor Circuit High Voltage
1000 & 2000 Gen 4 $50.00 -
-
Bendix ABS EC-30 Fault Code: SID 251 FMI 3
Bendix ABS -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P1688 Unmanaged Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0873 Transmission Pressure Switch Solenoid E Circuit High
1000 & 2000 Gen 4 $50.00 -
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U0031 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
