Detroit DD15 GHG14 (2014-16) Fault Code: SPN 3058 FMI 10 (MCM) Exhaust Gas Recirculation Valve Actuator Slow Response
DESCRIPTION:
This code sets when the actual EGR flow vs. desired EGR flow is greater than a calibrated threshold during acceleration.
MONITORED PARAMETER:
1. EGR delta P sensor.
2. Intake manifold pressure sensor.
3. Intake manifold temperature sensor.
TYPICAL ENABLING CONDITIONS:
Low engine to high engine load.
MONITOR SEQUENCE:
1. One second after acceleration load.
2. Actual EGR flow vs. desired EGR flow is greater than a calibrated threshold.
EXECUTION FREQUENCY:
Always enabled
TYPICAL DURATION:
Five seconds
DASH LAMPS:
1. MIL
2. CEL
ENGINE REACTION:
None
VERIFICATION:
1. Road test with a trailer while performing multiple accelerations.
2. Engine load needs to increase above 50% during accelerations and the engine rpm is between 600 and 900 rpm.
PROBABLE CAUSES:
1. If any voltage codes exist, fix those first.
2. EGR valve actuator pull rod.
3. EGR actuator.
4. EGR valve.
5. Wiring between the EGR actuator harness and the ECM.
![Volvo Penta EPC 6 Offline VMware [12.2021] VMware](https://www.ecuforcetruck.com/wp-content/uploads/2022/11/VOLVO-PENTA-2021-A-300x300.jpg)
Related products
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1000 Class 2 Loss of Serial Data Communication
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P1688 Unmanaged Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0218 Transmission Fluid Over Temperature Condition
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1041 J1850 (Class 2) ABS Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
-
Bendix ABS EC-30 Fault Code: SID 251 FMI 3
Bendix ABS -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1301 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
