Detroit DD15 GHG14 (2014-16) Fault Code: SPN 110 FMI 2 (MCM) Coolant Outlet Temperature Not Plausible
DESCRIPTION:
Coolant outlet temperature not plausible.
MONITORED PARAMETER:
Coolant inlet and coolant outlet temperature sensors.
TYPICAL ENABLING CONDITIONS:
1. Engine speed 500-2500 rpm.
2. Coolant temperature is greater than 65C.
3. Battery voltage is 11 vDC.
4. Run engine less than 60s.
MONITOR SEQUENCE:
None
EXECUTION FREQUENCY:
Always enabled
TYPICAL DURATION:
30
DASH LAMPS:
MIL
VERIFICATION:
Start engine, warm it up so that the coolant temperature is greater than 65C. Insure battery voltage is 11 vDC and engine has been running for at least 1 minute then bring engine to idle speed, being certain that it is greater than 500 RPM.
NOTE: If any other cooling system issues, repair those first.
PROBABLE CAUSES:
1. Engine cooling system thermostat failure.
2. Inlet and/or outlet coolant temperature sensor connector/harness.
3. Inlet and/or outlet coolant temperature sensor.
Related products
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P1779 Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1300 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0873 Transmission Pressure Switch Solenoid E Circuit High
1000 & 2000 Gen 4 $50.00 -
-
Bendix ABS EC-30 Fault Code: SID 251 FMI 3
Bendix ABS -
Allison 1000 & 2000 Gen 4 Fault Codes: U1301 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P1688 Unmanaged Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0123 Pedal Position Sensor Circuit High Voltage
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1096 J1850 (Class 2) IPC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
