Detroit DD15 EPA10 (2010-13) Fault Code: SPN 3250 FMI 15 (ACM) Diesel Oxidation Catalyst Outlet Temperature High
NOTE: Please see the step by step troubleshooting procedures for this specific code.
NOTE: If any other codes active, fix those first.
PROBABLE CAUSES:
1. Inspect the DOC outlet temperature sensor connector/harness.
2. Check connections upstream of the ECM (ATD harness 10-pin connector, VIH 31-pin connector, and MCM 120-pin connector).
3. DOC outlet temperature sensor.
4. Failed cylinder injector.
5. Inspect the DPF face for oil or coolant contamination – if present, find source.
6. Perform a parked regen.
Related products
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1000 Class 2 Loss of Serial Data Communication
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0218 Transmission Fluid Over Temperature Condition
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1096 J1850 (Class 2) IPC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P1688 Unmanaged Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0848 Transmission Pressure Switch Solenoid D Circuit High
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1301 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00
