Detroit DD13 GHG14 (2014-16) Fault Code: SPN 84 FMI 13 (CPC) J1939 Wheel-Based Vehicle Speed Signal from Source #1, #2 or #3 is Missing
DESCRIPTION:
J1939 wheel based vehicle speed signal from source #1 is missing.
MONITORED PARAMETER:
Vehicle Speed Sensor (VSS).
TYPICAL ENABLING CONDITIONS:
1. Rpm greater than 1500.
2. Torque demand on.
MONITOR SEQUENCE:
None
EXECUTION FREQUENCY:
Continuous when enabling conditions met.
TYPICAL DURATION:
10 seconds
DASH LAMPS:
MIL
VERIFICATION:
1. Rpm greater than 1500.
2. Torque demand on.
NOTE: If codes for other modules are present, fix those first.
PROBABLE CAUSES:
1. Improper programming of the CPC (Common Powertrain Controller).
2. Other failed modules on the truck (Transmission, ABS, Cab controller, etc…).
3. Battery/battery cable issues, or electical issue on truck.
![DOOSAN DMS-5 3.1.3 [2023.11] diagnostic software](https://www.ecuforcetruck.com/wp-content/uploads/2023/11/1-300x300.png)
Related products
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1096 J1850 (Class 2) IPC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P1779 Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
-
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1041 J1850 (Class 2) ABS Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0876 Transmission Reverse Pressure Switch Circuit Stuck Open
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P2771 Four-Wheel Drive Switch Circuit
1000 & 2000 Gen 4 $50.00 -
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1300 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0218 Transmission Fluid Over Temperature Condition
1000 & 2000 Gen 4 $50.00
